9001 AIRPORT RD 2021-12-20 - Laserfiche WebLink

•. 0 9 Y • ll 0 - - - • I - - � • • U 2018 WSEC Requirements for Commercial Buildin cluding Group R2,R3&R4 over 3 stories&all R1 -- • inistered by©2021 NEEA,All rights reserved The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com NA C406.4 Enhanced digital To comply with additional efficiency credit, lighting controls indicate on plans that interior lighting fixtures are configured with all of the following control functions,as applicable: 1)Each fixture is individually addressed,or exception taken;2)Fixtures are configured for continuous dimming;3)No more than eight fixtures are controlled by a single daylight sensor;4)In enclosed and open office areas, illumination levels of overhead general area lighting is configured to be individually adjusted by occupants NA Include calculations that demonstrate the total lighting power of all interior lighting fixtures configured with enhanced lighting controls is no less than 90%of the total interior lighting power for the area the enhanced lighting controls credit is being applied to INTERIOR LIGHTING POWER&EFFICACY YES C405.4.1 Total connected Include all luminaires in interior lighting E0.01 C405.4.2 interior lighting fixture schedule;indicate fixture types,lamps, power ballasts,and manufacturer's watts per fixture for the installed lamp NA Identify spaces eligible for lighting power exemption on plans and in WSEC interior lighting compliance reports;indicate the exception applied NA ' Identify lighting equipment eligible for lighting power exemption in fixture schedule and in WSEC interior lighting compliance reports;indicate the exception applied NA C405.1 Lighting in dwelling For all installed luminaires,include lamp type C405.1.1 units(multifamily) and number of lamps in lighting fixture schedule;for lamps that are not LED,T-8 or small diameter fluorescent,indicate efficacy of other lamp types is 65 lumens per watt or greater NA For all installed luminaires,indicate in lighting fixture schedule whether complying via lighting power density or by qualifying lamp type;if by lamp type,include number of lamps NA For all installed luminaires,indicate in lighting fixture schedule whether complying via lighting power density or by qualifying lamp type;if by lamp type,include number of lamps INTERIOR LIGHTING POWER CALCULATION-INDICATE COMPLIANCE PATH TAKEN NA C405.4.2.1 Building Area Demonstrate that total proposed wattage per Method building area does not exceed maximum allowed wattage per building area;identify locations of building areas on plans;provide WSEC exterior lighting compliance reports Page 5/10