2201 100TH ST SW AD SYSTEMS 2022-03-07

Exterior Li • htin • `j LTG-EXT 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: AD Systems Warehouse Addition Date 9/5/2017 Exterior Lighting For Building Department Use O Zone 1 0 Zone 2 ® Zone 3 0 Zone 4 Zone Table C405.5.2(1) Specified by jurisdiction. Zone selection required to enable LTG-EXT form Calculation Area O O Addition- O Addition stand alone +existing O Alteration with<50% O Alteration with>_50%ext. ext.wattage replaced wattage replaced Building Grounds n Efficacy>80 lumens/watt I I Exemption Applies to luminaires> 100 Watts Controlled by motion sensor Tradable Maximum Allowed Lighting Wattage NOTE' Base Site Allowance: 750 Area(ft2),perimeter Allowed Watts Allowed Watts Tradable Surfaces Surface Description (If)or#of items per ft2 or per If x ft2(or x If) Other Entry Door Warehouse entry 2 20W/LF door 40 Total Allowed Tradable+Site Allowance Watts: 790 Tradable Proposed Lighting Wattage NOTE 2 Number of Watts per Watts Tradable Surface Fixture Description NOTE s,a Fixtures Fixture NOTE a Proposed Other Entry Door 100 watt equivalent LED wall pack 2 100 200 Total proposed tradable watts may not exceed the sum of total allowed tradable Total Proposed Tradable Watts: 200 watts plus the base site allowance. Any base site allowance not needed to make tradable watts comply can be applied to individual non-tradable categories. Non-Tradable Maximum Allowed Lighting Wattage""'t' g g g Site Allowance Remaining: 750 Area(ft2), perimeter Allowed Watts Allowed Watts Non-Tradable Surfaces Surface Description (If)or#of items per ft2 or per If x ft2(or x If) Non-Tradable Proposed Lighting Wattage NOTE 2 Number of Watts per Watts Non-Tradable Surface Fixture Description NOTE s,4 Fixtures Fixture NOTE e Proposed Non-tradable proposed watts may not exceed allowed watts for any individual Non-Tradable Watts Exceeding LPA: 0 surface unless the total excess watts for all non-tradable surfaces are less than the remaining site allowance. Remaining Site Allowance: 750 Exterior Lighting COMPLIES WITH MAX. ALLOWANCE Note 1-List all unique exterior sufaces per Table C405.5.2(2)that occur in the project scope. Select exterior surface categories from drop down menu. Note 2-List all proposed lighting fixtures including existing-to-remain fixtures. Note 3-For proposed Fixture Description, indicate fixture type, lamp type, number of lamps in the fixture, and ballast type(if applicable). Note 4-Existing-to-remain fixtures shall be included in the Tradable and Non-Tradable Proposed Lighting Wattage tables in the same manner as new fixtures. Identify as existing in fixture description. Note 5-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source. For luminaires with screw-in lamps, enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage). For low voltage lighting, enter the wattage of the transformer.