Always Active Services LLC of Seattle 7/21/2022

I 1 I 2 Conduit Sealing 3 Mechanical plugs for cabinet conduit sealing shall be one of the following: 4 I 5 1. Tyco Electronics -TDUX 6 2. Jackmoon —Triplex Duct Plugs 7 3. O-Z Gedney—Conduit Sealing Bushings I 8 9 The mechanical plug shall withstand a minimum of 5 psi of pressure. 10 11 Rigid Metal Conduit Fittings and Appurtenances 12 13 Section 9-29.1(2) is supplemented with the following: 14 Conduit Coatings I 15 Electroplated couplings are not allowed. 16 17 Surface Mounting Conduit Attachment Components I 18 Channel supports and all fastening hardware components shall be Type 304 19 stainless steel. Conduit clamps shall be one piece, two bolt units with lock 20 washers. I 21 22 Non-Metallic Conduit 23 Section 9-29.1(4) is supplemented with the following: 24 I 25 PVC conduit shall be either Schedule 40 or Schedule 80, as indicated on the plans. 26 Schedule 80 shall be required for all street crossings and for the bottom 10' of pole 27 risers. Schedule 80 shall be used for all conduits that are installed using Directional 28 Bore method. Bell end bushings shall be installed on all conduit ends. Conduit runs, 29 without innerduct, installed using directional boring method shall be Schedule 80 high 30 density polyethylene (HDPE) if the runs enter/cross the traveled way or shoulder, I31 and Schedule 40 HPDE for runs that do not enter or cross the traveled way or 32 shoulder. 33 34 CNH 8-20.2(9-29.2) Junction Box.RTF I35 36 9-29.2 Junction Boxes, Cable Vaults, and Pull Boxes 37 38 39 Section 9-29.2 is supplemented with the following: 40 All junction boxes shall conform to the details shown on the WSDOT Standard I 41 Drawings J-40 series, City of Everett Standard Drawing 808, and shall be of the type 42 indicated in the plans. All junction box lids and frames shall be galvanized and those 43 installed within sidewalk areas shall be slip-resistant. All junction boxes shall have I 44 base sections as shown in City of Everett Standard Drawing 808. All junction boxes 45 to be located in the street or shoulder area shall be heavy duty junction boxes as 46 detailed in Standard Plan 1-40.20 and described in Section 9-29.2(1)B. I 47 48 Vaults shall be as indicated on the drawings shall be 233-LA, 444-LA and 504-LA, or 49 approved equivalent. Lids for the vaults shall be 23-2436P, 44-332P and 55-332P, 50 respectively and shall be slip-resistant. I INTERURBAN TRAIL TO YMCA PEDESTRIAN IMPROVEMENTS SPECIAL PROVISIONS IWORK ORDER 3749 Page SP53 of SP68 MAY 2,2022 I