Laserfiche WebLink
Assessment of interrupting rating and arc -flash labeling of the equipment being <br />evaluated is beyond the scope of this field evaluation. Calculations to confirm <br />adequate equipment interrupting rating and arc -flash labeling are the <br />responsibility of the end -user as described in subsection 6.5 of this report. <br />This acceptance applies to the electrical circuits and components only, as <br />referenced in this report. Unless noted otherwise, it specifically excludes <br />examination for suitability of use for equipment involving toxic or corrosive gases, <br />steam, and locations defined as hazardous by the National Electrical Code <br />(NEC). <br />4.0 REFERENCED ELECTRICAL STANDARDS <br />4.1 ANSI/NFPA 79, Electrical Standard for Industrial Machinery-2021 <br />4.2 UL 508A, Industrial Control Panels-2021 <br />4.3 ANSI/UL 508, Industrial Control Equipment-2021 <br />4.4 ANSI/NFPA 70, National Electrical Code (NEC)-2020 <br />5.0 EQUIPMENT INSPECTED <br />5.1 Scanners Added to Robots <br />Manufacturer Name: Electroimpact <br />Model No.: Mobile Robot <br />Serial No.: 3838-001/3838-002 <br />Ratings: 480VAC, 3 Phase, 60HZ, 40 Amps, Largest Load 9 Amps, 10 <br />KA <br />eti CS Label No.: 2054793/2054794 (Existing 2025743/2025798) <br />6.0 INSPECTION PROCEDURES <br />6.1 Component Listing <br />The following major power components are inspected for listing marks by <br />an independent testing laboratory acceptable to the authority having <br />jurisdiction (AHJ), or are evaluated to the appropriate nationally <br />recognized consensus standard. Any discrepancies observed during the <br />evaluation process are noted in Section 7.0. <br />• Circuit breakers <br />• Fuses and fuse holders <br />• Disconnect switches <br />• Terminal blocks <br />• Transformers <br />• Motors and drives <br />• Motor overload units <br />• Wire ducts <br />Reference No.: 1099539 Page 2 <br />