3003 W CASINO RD BLDG 40-23 2023-04-19

sufficient for the nominal circuit voltage and the current that is available at the line terminals to the equipment." "Equipment intended to interrupt current at other than fault levels shall have an interrupting rating at nominal circuit voltage sufficient for the current that must be interrupted." 110.16 Flash Protection. "Switchboards, panelboards, industrial control panels, meter socket enclosures, and motor control centers that are in other than dwelling occupancies and are likely to require examination, adjustment, servicing, or maintenance while energized shall be field marked to warn qualified persons of potential electric arc flash hazards. The marking shall be located so as to be clearly visible to qualified persons before examination, adjustment, servicing, or maintenance of the equipment." eti Conformity Services would be happy to provide a proposal for above services upon receiving a request from the customer. 6.6 Internal Wiring Internal wiring and wiring methods are evaluated for compliance with the applicable codes and standards referenced in Section 4.0. Wiring is verified to be properly sized and rated, with a temperature rating suitable for the installed application. 6.7 Safety Interlocks and Operator Controls The equipment safety interlocks, emergency stops, operator controls and human machine interfaces (HMI) are verified to be properly identified. The safety features and emergency machine off (EMO) switches are tested for proper operation. 6.8 Field Testing Field testing is performed on the equipment, to meet the field testing requirements of the standards referenced in Section 4.0, unless production test results have been provided by the equipment manufacturer and accepted by eti Conformity Services. If no production tests are submitted, then testing is performed to verify the equipment to be operating within normally expected parameters as detailed in Section 8.0. Reference No.: 1099539 Page 4