Laserfiche WebLink
6.4 Installing the Inner Modules <br /> Inner modules of the array are secured with mid clamps. All mid clamps are provided with integral bonding plates. Mid <br /> clamps are designed to fit modules within a particular range. Mid clamps are available in either mill finish or black in the <br /> following size ranges: <br /> Part Number <br /> Finish Clamping Range (mm) Clamping Range (inches) <br /> bonding plate 2-pin <br /> 872 900 mill 30-45 1.30-1.77 <br /> 877 902 black 30-45 1.30-1.77 <br /> 873 901 mill 38-50 1.50-1.97 <br /> 878 903 black 38-50 1.50-1.97 <br /> Table 6.4.1 <br /> Mounting steps: <br /> ■ Insert the QClick of the mid clamp into the QClick channel of the rail. The flat sides of the QClick make it possible to <br /> install the QClick flush against the module side. <br /> ■ Slide the module clamp flush against the side of the module by squeezing the QClick legs and pushing the clamp <br /> against the side of the module. Ensure the bonding plate is above the module frame. <br /> ■ Slide the next module under the clamp head and flush against the QClick body. <br /> ■ Using a 5 mm Allen key, tighten the clamp bolt onto the modules. Tighten the clamp bolt to 12 ft-lbf (16 N-m). <br /> Material damage due to incorrect mounting <br /> Incorrectly mounted modules can fall and become damaged <br /> ' ■ Make sure the clamps are installed correctly. <br /> ■ Ensure the module is installed flush and tight against the side of the mid clamp. <br /> DANGER ■ Ensure proper torque of the mid clamp mounting bolt 12 ft-lbf(16 N-m). <br /> 6.5 Installing Additional Module Rows <br /> Mounting steps: <br /> ■ Additional module rows are by repeating steps in sections 6.1-6.4. <br /> NOTE! <br /> Use of a spare module clamp QClick or other item as a spacing <br /> gauge between the top of one row of modules and the bottom of <br /> another can help provide a neat, aesthetically pleasing array. <br /> B1 7.2.3-46 28 Jul-2019, Rev 4.2 <br />