Laserfiche WebLink
Mounting Steps, Hidden End Clamps: <br /> ■ After installation of rails and prior to installation of the modules <br /> slide the Hidden End Clamp into both sides approximately <br /> inches from the end of the rail. See Image 6.3.4 <br /> 9 <br /> ■ Install first module insuring the module frame is flush with the <br /> end of the rails. See Image 6.3.5 <br /> ■ Slide Hidden End Clamp over until it fully engages with the <br /> module flange. See Image 6.3.6 <br /> 1 m age 6.3.4 <br /> ■ Tighten Hidden End Clamp bolt to 9 ft-lbs (Using Ratchet or <br /> right angel tool). See Image 6.3.7 <br /> ■ At end of module row place final module in place (Do not <br /> tighten mid clamps) and mark the edge of the module on the _ <br /> rail andp ick u module. <br /> p �,. <br /> ■ Cut Rail at the marked location _ <br /> ■ Replace module and tighten Mid Clamps �• <br /> ■ Slide final Hidden End Clamp overto fully engage flange of the <br /> module <br /> ■ Tighten Hidden End Clamp Bolt to 9 ft-lbs (Using ratchet or Image 6.3.5 <br /> right angle too[) <br /> ■ Place End Caps onto rails <br /> j <br /> I m age 6.3.6 <br /> NOTE! <br /> The QRail Hidden End Clamp is NOT a bonding solution and <br /> therefore cannot be used on single modules. It must always be <br /> installed in conjunction with at least one Bonding Mid Clamp. <br /> I m age 6.3.7 <br /> B1 7.2.3-46 27 Jul-2019, Rev 4.2 <br />