10330 EVERGREEN WAY GLINT CAR WASH 2023-04-10

Building Envelope Requirements List, pg 3 of 8 2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1 -- Administered by ©2021 NEEA, All rights reserved The following information is necessary to check a building permit application for compliance with the building envelope requirements in the Washington State Energy Code. Commercial Provisions. For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com l I S C402.2.1.2 Rooftop HVAC Indicate rooftop HVAC equipment curb A4-1 equipment curbs insulation R-value on roof section YES C103.2 Above/below grade Indicate R-value(s) of cavity/continuous A7-2 C402.2.3 wall insulation insulation on wall sections C402.2.4 YES C303.2.1 Indicate framing materials on wall sections A7-2 YES Indicate method of framing for wood A7-2 construction per A 103.2 (std, int, adv) NA Indicate material density category, wall weight and heat capacity for qualifying mass walls NA For qualifying ASTM C90 masonry walls, indicate loose -fill core insulation material and percentage of cores filled including grouted cores, bond beams, vertical fills, headers and any other grouted cores NA Indicate method of protection of exposed exterior basement/crawlspace wall insulation YES C103.2 Opaque doors Indicate rated U-factor or R-value (non- 2-1 C402.4.4 swinging) on wall sections or in door schedules - applies to doors with less than 50% glazed area NA C402.4.4 Garage doors Indicate rated U-factor for sectional and tilt - up garage doors on wall sections or in door schedules - applies to garage doors with less than 14% glazed area; all other garage doors shall comply as opaque doors NA C402.2.5 Floor over outdoor or Indicate R-value(s) of cavity/continuous unconditioned space insulation on floor sections insulation NA Indicate framing material on floor sections Indicate material density category and weight of qualifying mortis floor% YES C402.2.6 Slab -on -grade floor Indicate R-value of continuous insulation on A6-1, A6-2 C303.2.1 insulation wall section or foundation detail YES Indicate insulation extends down vertically A6-1, A6-2 and/or horizontally the required distance from top of slab NA Indicate method of protection of exposed exterior slab edge insulation NA Indicate R-value of continuous insulation on wall section or foundation detail NA Indicate insulation extends down vertically from top of slab and then horizontally under the entire slab NA Indicate method of protection of exposed exterior slab edge insulation Page 318