Laserfiche WebLink
ARTICLE 9 : EMISSION STANDARDS <br /> SECTION 9.03 EMISSION OF AIR CONTAMINANT: VISUAL STANDARD Adopted 03/13/68(12) <br /> Revised 07/08/70(126),04/11/73(186),06/09/88(621)05/11/89(643),09/08/94(798),04/09/98(865),03/11/99(881),03/25/04(1024) <br /> (a) It shall be unlawful for any person to cause or allow the emission of any air contaminant for a <br /> period or periods aggregating more than 3 minutes in any 1 hour, which is: <br /> (1) Darker in shade than that designated as No. 1 (20% density) on the Ringelmann Chart, as <br /> published by the United States Bureau of Mines; <br /> or <br /> (2) Of such opacity as to obscure an observer's view to a degree equal to or greater than does <br /> smoke described in Section 9.03(a)(1). <br /> (b) The density or opacity of an air contaminant shall be measured at the point of its emission, <br /> except when the point of emission cannot be readily observed, it may be measured at an <br /> observable point of the plume nearest the point of emission. <br /> (c) This section shall not apply when the presence of uncombined water is the only reason for <br /> the failure of the emission to meet the requirements of this section. <br /> (d) This section shall not apply to solid fuel burning devices, permitted fire training facilities, <br /> permitted obscurant usage during military training operations, outdoor fires, motor vehicles <br /> when operated on public roads, aircraft, or equipment subject to Section 9.04 of this <br /> regulation. <br /> (e) This section shall not apply to equipment with an alternate opacity standard issued under <br /> Section 3.03 or Article 6 of this regulation that is based upon a correlation with the particulate <br /> concentration and that accurately indicates a violation of the applicable particulate emission <br /> standards in Section 9.09 of this regulation. <br /> SECTION 9.04 OPACITY STANDARDS FOR EQUIPMENT WITH CONTINUOUS <br /> OPACITY MONITORING SYSTEMS Adopted 04/09/98(865) <br /> Revised 03/25/04(1024) <br /> (a) Applicability. This section shall apply to all equipment required to be equipped with a <br /> continuous emission monitoring system for opacity. <br /> (b) It shall be unlawful for any person to cause or allow the operation of any of the following <br /> equipment unless equipped with a continuous emission monitoring system for opacity: <br /> (1) Cement kilns; <br /> (2) Clinker coolers; <br /> (3) Glass furnaces, rated at greater than 1 ton per hour, that burn fuel; <br /> (4) Fuel burning equipment, rated at 100 million Btu per hour or greater,that burns wood, <br /> coal, or residual oil; and <br /> (5) Refuse burning equipment rated at greater than 12 tons per day. <br /> (c) It shall be unlawful for any person to cause or allow the emission of any air contaminant from <br /> any equipment subject to this section during any hour that: <br /> (1) Averages greater than 5% opacity; or <br />