Laserfiche WebLink
E=01& <br /> mil <br /> A. SLIDE INTO RAIL B. PLACE MODULE <br /> Slide CAMO into rail channel far enough to clear the Place module on rails (module cells not shown for <br /> module frame. CAMO requires 6" of clearance from end of clarity). When installing CAMO the module can <br /> rail. overhang the rail no more than 1/4". <br /> A B <br /> C. PULL TOWARDS END D. SECURE TO FRAME <br /> Pull CAMO towards rail ends, at 45 degree angle, so the Rotate handle with an upwards motion until CAMO <br /> bonding bolt contacts the module flange edge. snaps into rail channel. Ensure CAMO bonding <br /> pins are fully seated on top of module frame. <br /> C D <br /> FRAME COMPATIBILITY <br /> CAMO has been tested or evaluated with all modules listed in the <br /> Module Compatibility section having frames within the referenced Module Glass/Cells <br /> dimensions. Be sure the specific module being used meets the <br /> dimension requirements. <br /> For installations with Hanwha Q CELLS modules with 32 mm frame heights, Frame Compafibility: <br /> X=1.2-2.2 mm <br /> the maximum ground snow is 45 PSF(33 PSF module pressure). Y=15-40mm <br /> CAMO is only compatible with Canadian Solar modules CS1YxxxMS and -y-L . <br /> CS3N-xxxMS. "xxx"refers to the module power rating --T <br /> :1101►I I I L,[CMM iyj l»:Mil <br /> 8" Bonding Jumper is an electrical bonding jumper that can <br /> be used on the Flush Mount System for row to row bonding; <br /> making the module frames the medium for the equipment <br /> ground path. <br /> Bonding jumper is pushed onto the bottom flange of the module. <br /> New jumpers should be used if re-installation of jumper is required. <br /> Supports bottom flange thicknesses from 1.2mm to 3.1 mm. <br /> o i - • . • FLUSH MOUNTINSTALLATION <br />