4319 CRESCENT AVE 2023-05-11 - Laserfiche WebLink

Wilr MEEEMM7F- Orient Base to desired position Tighten until fully seated Remove tile and mark rafter. Use base as guide to drill 1/4" pilot hole and fill with roofing manufacturer's approved sealant. Install optional Roof Flashing and seal appropriately. Insert lag bolt with bonded washer through Rafter base (and flashing if used)and drive until fully seated. Insert Tile Replacement Flashing, lower onto base and apply pressure over the threaded post until it dimples the flashing. Place L-Foot over dimple and tap with hammer to punch threaded post through the flashing. Ensure punchedTa with pieces of flashing are cleared away. Form flashing as H mme needed to sit flush with surrounding tiles, position L-Foot in Dmple desired orientation and torque hardware to 132 in-lbs (11 ft-lbs).Attach rail to L-Foot with Aire Dock and torque to 250 in-lbs (21 ft-lbs). Base can be installed in any orientation relative to rafter. Ensure L-Foot does not extend above rail. Optional deck level flashing is available.Standalone nsta.l.la...ton_._ man.u....a..l available on website rq Standalone K.n...ock...out_Tile._.m....an.u.al available on website. Tor uet 2 � - 1 in-1 QM TILE REPLACEMENT Remove tile and mark rafter. Measure up 8 3/4"from the adjacent tiles and mark horizontal across rafter. Align baseplate over rafter so that the lag holes align with the post groove. The orientation of the plate can be adjusted 0 cross roof, mark location of lag holes on the roof. Drill two 1/8" Pilot holes and back fill with roofing manufacturers' o approved sealant. Waterproof at underlayment level according to roofing manufacturers' instructions and the L Tile Roofing Industry Alliance guidelines. Use T-30 Torx bit to lag base into position. Insert Grade 8 Serrated Flange Bolt Into bottom of the Post, slide Post Into Base channel. Line up post with the hole in the Tile Replacement Flashing. Leave loose for adjustments. Place Tile Replacement Flashing over the Post and Mount, allowing the flashing to properly interlock with surrounding tiles. Secure Post by tightening with channel lock pliers. Replace all tiles. Apply a bead of sealant where the post meets the flashing, slip EPDM collar over post and down to flashing.Attach L-Foot on Standoff with hardware. Torque to 174 in-lbs (14.5 ft-lbs). Attach rail to L-Foot with Bonding Hardware and torque to 250 in-lbs (21 ft-lbs). C If deck level flashing is required,approved flashing methods include user supplied adhesive backed flexible flashing. C For additional details refer to the full QM Installation Manual.