4319 CRESCENT AVE 2023-05-11 - Laserfiche WebLink

ilr ALL TILE . . Remove tile and mark rafter. Position base over rafter, adjust arm if necessary and torque hardware to 132 in-lbs (11 ft-lbs). Use base as guide to drill 1/4" pilot holes, back T queto 32 in-lbs fill with roofing manufacturer's approved sealant, then insert lag bolts and tighten until fully seated. Replace tiles /Rafte o and notch as necessary to ensure proper fit.Attach rails to either side of slot using Bonding Hardware and torque to 250 in-lbs (21-ft-lbs). Position arm near the center of valley for curved tiles. Position arm away from seam of joining flat tiles. T ➢ Ensure top of hook does not extend above rail. ten Until u aliy seated • _lbs Standalone All Tile Hook manual available on website. 0 e� K01 M K0111 • • . Remove tile and mark rafter, use Base Plate to mark two holes on rafter. Drill two 7/32" pilot holes and back fill with roofing manufacturers' approved sealant. Use 1/2" e socket to drive lag into place. Slide hook into place and adjust to desired position. Drive self-tapping screw using a#3 Phillips bit to lock hook in place. Clean underlayment and apply a bead of sealant compatible with roofing manufacturer, install flashing over mount. Fasten sub- flashing to deck with one roofing nail in each corner. Waterproof at underlayment level according to roofing manufacturers' instructions and the Tile Roofing Industry Alliance guidelines. Cut clearance notch in the weather guard of tile as needed or utilize QM Tile Replacement Flashings. Attach rails to either side of slot using Bonding Hardware and torque to 250 in-lbs (21-ft-lbs). Position arm near the center of valley for curved tiles. Position arm away from seam of joining flat tiles. Ensure top of hook does not extend above rail. For additional details refer to the full QM Installation Manual. o 2022 IRONRIDGE, • • INSTALLATION