4319 CRESCENT AVE 2023-05-11 - Laserfiche WebLink

CONDUITilr CONDUITQM COMPOSITION Place conduit mounts along path of conduit. Lift shingle above mount location and insert flashing into position. Mark center for drilling, remove flashing and drill pilot hole with 1/8" bit. Clean area, fill hole with roofing manufacturer's approved sealant. Lift shingle and slide Conduit Mount into place. Prepare the lag bolt with sealing washer and pipe clamp (not included). Insert lag through hole in block and drill with 7/16" socket until block is tight. Install mounts as required to support conduit across the roof. For additional details refer to the full QM Installation Manual. Remove the tile that the mount will be installed on, and the tiles in the course above it. Lift the bottom of the tile and slide the bottom clamp over the bottom edge of the tile. Insert the 4"tap bolt through the slot into the threaded hole and use a 7/16" socket to thread the screw. Tighten until the top clamp hook end unbends and forms a 90 degree angle with the tile. Use the Cap Screw(included)to attach your pipe clamp (not included)to bottom clamp. Insert conduit and tighten with 7/16" socket. The clamp is reversible,use the wider hook end on tile greater than 1"thick and the thinner hook end on tiles less than 1"thick. The installation process is the same on curved tile,make sure that the Conduit Mount is installed on the crown(high point)of the tile. D Install mounts as required to support conduit across the roof. D For additional details refer to the full QM Installation Manual. ........................................................................ CE33EL ■ End Caps add a completed look and keep debris and pests from collecting inside rail. Firmly press End Cap onto rail end. a(oy `oz o o ➢ End Caps come in sets of left and right.Check that the proper amount of each has been provided.