Laserfiche WebLink
Remote <br />Verify the Switch is on "REMOTE" <br />The battery holder has a switch built into it (see Figure 1). This switch must remain in the REMOTE <br />position for the remote to operate. <br />M <br />FI9ur 1 <br />Synchronize the Transmitter to the IFC <br />The transmitter will need to be synchronized to the IFC (integrated Fireplace Control) before the remote <br />will work correctly. Synchronizing is done in the following two steps below (see Figure 2); <br />1. Press the PRG (Program) button on the battery box (IFC will beep 3 times). <br />2. Press the 'ON" button on the transmitter (IFC will beep 3 times). <br />Fleur 2 <br />NOTE: If Power is cut off to the IFC for an extended period of time, you may need to re - <br />synchronize the remote. <br />Clearina the System Memory <br />This appliance uses an Integrated Fireplace Control (IFC) to store the unique code for the remote control. <br />If you wish to dear the system memory, MAKE SURE GAS IS TURNED OFF TO THE APPLIANCE then <br />press the PRG (Program) button for 10 seconds. The pilot will start to spark repeatedly, signifying all <br />system memory has been cleared. The system will return to its original configuration: a remote will need <br />to be synchronized; and, the system will operate under continuous pilot mode. <br />0 Travis Industries 4se/2023 -1521 430 EG GSR2 <br />