Laserfiche WebLink
Operation Model: FSH-2, FSH-2A-99 <br /> 4.02.3 Baffle Filter Installation <br /> Q! WARNING The Baffle Filter has sharp exposed edges, which may cause cuts. Use due caution when handling and <br /> cleaning. Heavy duty rubber gloves are advised. <br /> Sharp edges <br /> (p Watch your <br /> fingers <br /> 2 <br /> BppFIE F11.TE 3 <br /> 1 <br /> o°o °oo <br /> 4 Switch arm <br /> must be <br /> actuated by <br /> the Baffle <br /> Filter when <br /> installed, as <br /> shown <br /> ( Insert back edge of filter into hood (to the back wall). <br /> (1) Lift front edge up behind Front Header Panel. <br /> 03 Pull filter forward until front edge rests on support ledge inside front panel. <br /> ® Allow back edge to drop down and rest on studs in the rear channel. <br /> IMPORTANT! As shown above, the filter body must engage and actuate the curved actuator lever located at the rear of <br /> hood, on the right side. Filter must be installed so that the slats/slots are vertical, NOT horizontal. <br /> 29 <br />