Laserfiche WebLink
Operation Model: FSH-2, FSH-2A-99 <br /> 4.03.3 ; Alarm <br /> Three LED lights on the control panel indicate the operational status of the Electronic Air Cleaner(E.A.C.) system. <br /> [ON] Indicates that the E.A.C. cell is installed, powered and operating. It is th only light ON when the system is <br /> operating normally. <br /> [WASH] This light turns ON to indicate: <br /> • Filter cell is not installed or is mis-aligned. <br /> • Collection fins contain excessive amount of captured grease residue. <br /> • There is poor contact the contact plate inside hood. CHECK <br /> • Too many Ionizer wires are missing. <br /> When the [WASH] light is ON, an alarm condition exists and air cleaner is not <br /> CHANGE NOW <br /> functioning. After approximately two (2) minutes, an intermittent (beeping) <br /> alarm tone begins sounding and shortly thereafter, power to the fryer under the <br /> hood is shutdown; the [FRYER POWER] light turns OFF. SNOOZE <br /> [WASH) light is NOT intented to be used as a signal for routine cleaning of the0 HOOD POWER <br /> cell, DO NOT use as such. Typically, the collection cell must be cleaned DAILY to OFRYER POWER <br /> ensure optimum performance. See Section 5.01.2, EAC Filter Cell Cleaning. FILTER&41SSING <br /> [CHECK] This light turns ON to indicate: <br /> • Ionizer wire broken and touching cell frame. START <br /> • Cell is damaged and has shorted to ground. <br /> • Collection fins are shorted because of excessive moisture. W • <br /> When [CHECK] light is ON, system is no longer functioning to clean the air, even <br /> though the hood continues to run and fryer remains powered. DO NOT OFF <br /> CONTINUE TO USE FRYER WHEN THIS CONDITION EXIST! <br /> The following actions may clear the alarm condition: <br /> 1. Turn OFF hood Power Switch. <br /> 2. Remove the E.A.C. cell and clean as described in Section 5.01.2. <br /> 3. Inspect the cell for broken or missing ionizer wires, bent fins, or other damage. Ionizer wires are replaceable <br /> (when ordering replacements, note length ... available in 16"or20"). Bent fins may be gently straightened by <br /> hand, such that no fin is touching an adjacent fin. A cell with excessive damage (broken frame, badly bent <br /> frame, broken insulators, etc) must be replaced. <br /> 4. Inspect the E.A.C. contact plate inside hood. Clean grease accumulation away with a mild degreasing cleaner <br /> and dry thoroughly. <br /> 5. Replace filter cell (Section 4.02.5) and restart Hood (Section 4.01). If the condition persist, contact a qualified <br /> service technician. <br /> If none of the LED lights turn ON when hood is started, the power supply may be faulty ... service is required. <br /> 33 <br />