1130 SE EVERETT MALL WAY HOME GOODS 2023-06-22

Lighting, Motor and Electrical Requirements List, pg 1 of 10 2018 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1 -- Administered by©2022 NEEA,All rights reserved • The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com Project: HOMEGOODS-2018 WSEC 1130-D SE Everett Mall Way Everett,WA 98208 Date: 2022-09-12 Applies Code Section Component Compliance Information Required In Permit Location in Building Department Documentation Documents Notes LIGHTING SCOPE C 103.1 Construction For a shell£core or tenant space(first build- documents-C,enert0 :.out)project,indicate if there is no lighting scope included in the project. YES C103.1 Construction For an alteration project,indicate if there is Elec Sheets documents-General no lighting scope included in the project. LIGHTING CONTROLS YES C405.2 Lighting controls, For all lighting fixtures,indicate lighting Elec Sheets general control method on plans for spaces and lighting zone(s)served,or exception taken C405.2, Luminaire level Indicate on plans all fixtures provided with Option 2 lighting controls LLLC in lieu of C405.2 lighting controls; (LLLC) provide description of control capabilities and performance parameters C405.2.5. Lighting in dwelling Indicate method of automatic control of all Item 3 units(dormitory, installed luminaires in dwelling units in C405.2.1.I hotel and all other buildings other than multifamily(occupancy C4052.3.1 than multifamily) or light reduction controls) C4052.5. Lighting in sleeping indicate method of automatic off control of Item 2 units .ill installed luminaires in sleeping units (vacancy or key card control):also refer to Receptacles-: YES C405.2.3 Manual controls Indicate on plans the method of manual Elec Sheets C405.2.3.1 lighting control,location of manual control C405.2.5 device and the area or specific application it serves YES C405.2.3.1 Manual interior light Indicate on plans which method of manual Elec Sheets C405.2.1.1 reduction controls 50%lighting load reduction is provided,or C405.2.4 indicate applicable exception YES C405.2.1 Method of automatic Indicate on plans the method of automatic Elec Sheets C405.2.2.1 shut-off control shut-off control during unoccupied periods C405.2.1, (occupancy sensor,time switch or digital Exception 3 timer switch)for all lighting zones NA C405.2.1 Occupant sensor Indicate on plans all luminaires that are controls controlled by occupant sensor controls; indicate controls are configured to turn luminaires 100%off when the space is unoccupied YES C405.2.1 Occupant sensor Indicate if occupant sensor controls are Elec Sheets C405.2.1.1 controls configured to be manual on or automatic on to not more than 50%power;indicate spaces eligible for exception that allows automatic on to 100%power Page 1/10