1130 SE EVERETT MALL WAY HOME GOODS 2023-06-22

Lighting, Motor and Electrical Requirements List, pg 8 of 10 2018 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1-- Administered by©2022 NEEA,All rights reserved • The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport©waenergycodes.com C503.6.3 Lighting panel Where a new interior and/or exterior lighting alterations panel is installed or an existing panel is moved (all new raceway and conductor wiring), indicate all applicable lighting controls requirements apply C503.6.4 Newly-created rooms Where interior space(s)is reconfigured (permanently installed walls or ceiling-height partitions)to create new enclosed spaces, indicate all applicable lighting controls requirements apply YES C504.2 Lighting repairs Identify existing luminaires being upgraded Elec Sheets with bulb and/or ballast replacement; indicate fixture alteration does not increase existing fixture wattage NA C505.1 Change of interior Identify spaces on plans where the building space use area type or space use type is being changed from one type to another per Tables C405.4.2(1)or(2) YES Indicate compliance method(building area or WSEC Reports space-by-space);include all new and existing- to-remain luminaires in WSEC interior lighting compliance reports;indicate proposed lighting wattage does not exceed maximum allowed per compliance path RECEPTACLES C405.l0 Controlled Identify all controlled and uncontrolled receptacles receptacles on electrical plans in each space in which they are required;include receptacle configuration such as spacing between controlled and uncontrolled,duplex devices, etc Provide schedule that lists the number of controlled and uncontrolled receptacles in each space where controlled receptacles are required-classrooms,private offices,open office au•cas,conference rooms,copy rooms, break rooms and modular partitions/workstations Indicate on plans the method or automatic control for each controlled receptacle zone (occupant sensor or programmable time-of- day control);indicate that each zone served by a single controller does not exceed 5,000 sf C405.2.5, Switched receptacles Indicate method of automatic off control of Item 2 in sleeping units all switched receptacles in sleeping units (vacancy or key card control) C503.6.6 Electrical receptacle Where new receptacles are added or replaced alerations within an alteration project that is 5,000 sf or larger,indicate receptacles are provided with automatic controls per C405.10.or exception taken MOTORS,TRANSFORMERS,ELECTRIC METERS,INTERIOR TRANSPORTATION Page 8/10 )