2722 COLBY AVE COMMUNITY HEALTH CENTER 2023-08-02

2015 Washinaton State Enerav Code Compliance Forms for Commercial Buildinas including R2. R3. R4 over 3 stories and all R1 Revised Nov 2017 Project Title: CHC-EVERETT Date 8. 8.2022 Change of Space Use ❑ Existing interior lighting systems in areas under -going a change in space use are upgraded to comply with LPAs for the new space types per Tables C405.4.2(1) or C405.4.2(2). Identify interior spaces requiring LPD upgrade to the current Code in Proposed Lighting Wattage table in LTG-INT-BLD or L TG-INT-SPA CE form. Interior and Exterior Lighting Power Interior lighting Parking garage Exterior lighting 50% or more of existing are replaced Lighting Alterations ❑ ❑ ❑ Select all Lighting Power and Lighting Control elements that apply to the scope of Less than 50% of existing are replaced ❑ ❑ ❑ the retrofit project. If project includes a combination of spaces where less than ❑ ❑ ❑ Lamp and/or ballast replacement only 50% of the existing fixtures are replaced in — existing total wattage not increased some spaces, and 50% others, then or more the fixtures are replaced n i 50% or more replaced - Total lighting power of new + existing -to -remain fixtures shall comply with total provide separate lighting power LPA per Sections C405.4.2 and C405.5.2. Include new + existing -to -remain fixtures in Proposed compliance forms for the two retrofit Lighting Wattage table in LTG-INT-BLD, LTG-INT-SPACE or LTG-EXT form. conditions. Spaces undergoing the same Less than 50% replaced - Total fighting power of new + existing -to -remain fixtures shall not exceed the type of retrofit may be combined into one total lighting power prior to alteration. Include new + existing -to -remain fixtures in the Proposed Lighting lighting power compliance form. Wattage table in LTG-INT-BLD, LTG-INT-SPACE or LTG-EXT form. 50% threshold applies to number of luminaires for interior spaces and parking garages, and total Refer to Section C503.6 for additional Lighting Controls Interior lighting Parking garage Exterior lighting requirements. All alteration lighting controls shall be New wiring installed to serve added fixtures and/or fixtures relocated to new ❑ ❑ ❑ circuit(s) New or moved lighting panel ❑ ❑ ❑ Interior space is reconfigured - ❑ J luminaires unchanged or relocated only New wiring or circuit - For interior lighting, provide required manual controls per C405.2.3, occupancy sensor controls per C405.2.1, daylight responsive controls per C405.2.4 and application specific lighting ❑ No changes are being made to controls per C405.2.5. For exterior lighting, provide required controls per C405.2.7. the interior or exterior lighting New or moved panel - Provide all applicable lighting controls as noted for New Wiring and automatic systems and existing space time switch controls per C405.2.2. uses and configuration are not Reconfigured interior space - Provide all required lighting controls that apply to a new interior space. changed. Application specific lighting control provisions per C405.2.5 do not apply to reconfigured spaces.