Laserfiche WebLink
• <br /> November 30, 2021 <br /> Dear Mr. Drew Martin, <br /> This letter and attached plans are in response to your letter dated August 20, 2021, and email <br /> dated October 26, 2021. <br /> ECEENET)) <br /> 1J1RE: Owner: Adam Baxter Fry-Pierce DEC o1 202, <br /> Job Address: 3217 54th Street SW <br /> Plan Check Number: B2108-010, First Building Review CITY OF EVERETT <br /> Permit Services <br /> General <br /> 1. The existing building as shown appears to have discrepancies with the available records and <br /> photography. For example, the windows in the east exterior wall at the Second and Third <br /> floor appear to be located farther north, leaving little to no wall between the windows and <br /> the building corner, whereas the plans should substantial wall between the windows and the <br /> building corner. Other discrepancies may occur. The existing condition of the building <br /> should be reviewed and the plans revised as needed. See IBC Section R106.1.1. <br /> Noted — plans have been updated accordingly <br /> 2. It appears that additional unpermitted work may have occurred in the house. For example, <br /> the existing building only appears to have a single bathroom located in the Master Suite. <br /> The drawings do not show other bathrooms, nor is the location of an existing bathtub or <br /> shower shown. All previously unpermitted work should be shown on the drawings and <br /> represented as new work under this permit application. All existing conditions to be <br /> demolished should be shown. See Sections R105.1, R106.1.1, and R113.1. <br /> Although existing plans on file show only exterior dimensions, the home is described as a three <br /> bedroom, three full or 3/4 bath house. Plans have been updated to show locations of these <br /> existing bathrooms in existing house. <br /> 3. The project may include work that requires an engineered design per Section R301.1.3 and <br /> additional comments below. Structural calculations substantiating the design should be <br /> submitted for review. Structural drawings and calculations should be sealed and signed by <br /> the FOR per RCW Sections 18.43.010, 18.43.020, and 18.43.070. See Section R106.1 and <br /> IBC Section 107.1. <br />