Laserfiche WebLink
<br />Page 12 of 27 <br /> <br />2.7.4 BODY DESIGN FEATURES <br />a. The body will have the following compartmentation: <br />1. One (1) full height compartment in front of the left rear wheels. The compartment will have two <br />(2) lower full depth adjustable height pull-out trays and two (2) upper full depth adjustable <br />shelves. <br />2. One (1) full height compartment in front of the right rear wheels. The compartment will have one <br />(1) lower full depth adjustable height pull-out tray and two (2) upper full depth adjustable <br />shelves. <br />3. One (1) compartment above left rear wheels. The compartment will have one shallow depth <br />adjustable shelf. <br />4. One (1) compartment above the right rear wheels. The compartment will have a swing out tool <br />board and mounting plate on the back wall. <br />5. One (1) full height compartment behind the left rear wheels. The compartment will have two (2) <br />lower full depth adjustable height pull-out trays and one (1) upper shallow adjustable shelf. <br />6. One (1) full height compartment behind the right rear wheels. The compartment will have two (2) <br />lower full depth adjustable height pull-out trays and one (1) upper shallow adjustable shelf. <br />7. One (1) compartment centered on the rear of the body with one (1) lower full depth adjustable <br />height pull-out tray and one (1) upper full depth adjustable height shelf. <br />8. Two (2) or more compartments near the rear wheels on each side designed to store SCBA bottles <br />and extinguishers. <br />9. One (1) long compartment located on each side above the body compartments. These <br />compartments will be accessed from both the top of the vehicle and through a hatch on the rear <br />of the body. <br />10. One (1) compartment in the front bumper capable of holding 100’ of 1.75” hose and an attached <br />TFT automatic nozzle. The compartment will have a hinged lid. <br />11. The body compartments #1 - #7 must have Amdor roll-up doors. <br />12. All shelving, pull-out trays and compartment bottoms will be outfitted with dry deck or <br />equivalent. <br />b. A ventilation system must be incorporated into all body compartments. Provide a powered ventilation <br />system supplying air to all body compartments. If possible, supply air to the main hose bed area. <br />c. The rear of the body will be flat with no inset. <br />d. A full width tailboard will be attached to the rear body. The tailboard will be of sufficient depth to <br />allow a firefighter to safely stand on while loading hose, yet not interfere with the twelve (12) degree <br />minimum angle of departure. <br />e. Provide a practical means from both pump panels to access the topside. Access must accommodate a <br />firefighter in full PPE including SCBA.