Laserfiche WebLink
Installation (For Qualified Installers Only) 13 <br /> Clearances <br /> ^ <br /> Insert must be placed so that no combustibles are within, or can swing within (e.g. drapes, doors), <br /> 38" (015mm)ofthe front ofthe heater. <br /> ^ <br /> Insert must boplaced aminimum 0" <br /> (229mm)from nside wall (or combustible <br /> protruding more than 3/4^ (20mm)). <br /> Mantel Requirements <br /> ^ <br /> The mantel must meet the requirements Minimum 36" <br /> (91m) <br /> shown inthe illustration tothe right. — <br /> ^ <br /> The non-combustible hearth must extend 6^ <br /> tothe front and sides cfthe firebox opening <br /> (you must open the door tomnouure). <br /> Placing the Insert <br /> ^ <br /> The insert must beplaced within an <br /> undamaged masonry orfactory built (meba|) <br /> fireplace. Loose bricks orother damage <br /> must befixed. Clean the fireplace before <br /> installing. <br /> Apply the"This fireplace has been <br /> altered..."sticker to the fireplace. You <br /> may wish to place it in a location where it <br /> Min.9" will be covered by the surround panels. <br /> Side Wall (229mm) <br /> The vent should be routed to <br /> the fireplace prior to installing <br /> the insert. See the section <br /> "Vent Installation"for details <br /> on vent location. <br /> Use the leveling bolts for <br /> j fireplaces with recessed <br /> floors. Un-screw the bolts <br /> prior to placing the insert. <br /> Place the insert so the back edge <br /> of the baseplete extends 14-1/4" <br /> (362mm)into the fireplace. <br /> Run the power cord to the side <br /> -��. <br /> (do not route-__ the-_,. <br />