Laserfiche WebLink
14 Installation • Qualified Only) <br /> Venting the Pellet Insert <br /> • INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER. <br /> • DO NOT CONNECT THE PELLET VENT TO A VENT SERVING ANY OTHER APPLIANCE OR <br /> INSERT. <br /> • DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT. <br /> • USE AN APPROVED WALL THIMBLE WHEN PASSING THE VENT THROUGH WALLS AND <br /> A CEILING SUPPORT/FIRE-STOP SPACER WHEN PASSING THE VENT THROUGH <br /> CEILINGS (MAKE SURE TO MAINTAIN CLEARANCE TO ANY COMBUSTIBLES). <br /> Maximum Venting Distance: <br /> • Maximum venting height is 35' (maximum horizontal offset is 10') <br /> • Use no more than 1800 of elbows (two 900 elbows, or two 450 &one 900 elbow, etc.). <br /> Pellet Vent Type <br /> • Must be Type "L" vent and/or Type "L" chimney liner. <br /> • 3" diameter vent may be used if vent is 20' or less. <br /> • 4" diameter vent is required if vent height is over 20'. <br /> Installing the Pellet Vent Seal each vent section (including <br /> adapters, elbows, etc...) by <br /> • Pellet vent connections must be sealed injecting a liberal amount of 500° <br /> airtight with 500° F. RTV silicone andF e F. RTV silicone into the gap <br /> screwed together with at least three 5s`°°e between sections. <br /> sheet metal screws. <br /> J.J.J.r:r: <br /> J.J.J.J.J. <br /> '. 4.1.1.1.1•......... <br /> •J•J•J•J• <br /> 1.4.4.1•;:.';:.'.:. <br /> r•J•J•J• The exhaust quick- <br /> connect can be <br /> 4`�•....... removed to allow for <br /> Einstallation and <br /> cleaning. <br /> Pellet Vent Termination <br /> • Termination must be a minimum 6" above the top of the chimney(NOTE: the chimney must meet <br /> local codes for height above the roof or other obstructions). <br /> • Must have an approved cap (to prevent water from entering). <br /> • Must not be located where it will become plugged by snow or other material. <br /> • This fireplace insert must be installed with a continuous chimney liner of 3" or 4" diameter <br /> extending from the fireplace insert to the top of the chimney. The chimney liner must conform to <br /> the Class 3 requirements of CAN/ULC-S636, Standard for Lining Systems for Existing Masonry or <br /> Factory-Built Chimneys and Vents, or CAN/ULC-S640, Standard for Lining Systems for New <br /> Masonry Chimneys. <br /> ©Travis Industries 4070806 100-01191000 <br />