Laserfiche WebLink
KS-PS Addressable or Kidde <br /> SmartOne® Protocol Fire Systems <br /> Photoelectric Smoke Detector Effective: October 2020 <br /> K-71-101 <br /> FEATURES <br /> • Multi-criteria optical smoke sensing technology • Detector head and terminal base design (bases sold <br /> • Advanced data analysis reduces chance of separately) <br /> nuisance alarms • Low-profile design blends into ceiling <br /> • Compatible with Kidde°, Fenwal°and Chemetron° • Suitable for raised floor and plenum applications <br /> intelligent control units . <br /> Attractive 6 in. diameter trim ring provided with bases <br /> • Works with SmartOne°communication protocol <br /> • Electronic addressing performed with SmartOne <br /> • Operates in conjunction with legacy SmartOne Hand-Held Programmer <br /> DS, PSD, CPD and THD smoke and heat detectors . <br /> FM Approved <br /> • Two-color(green/red)status LED <br /> • cULus Listed to UL268, 7th edition <br /> • Supports remote LED alarm indication <br /> • California State Fire Marshal Listed <br /> DESCRIPTION <br /> The KS-PS Photoelectric Smoke Detector is an intelligent <br /> device that gathers analog information from multiple optical <br /> sensors, converting this data into digital signals. Utilizing <br /> dual optical wavelengths combined with multiple detection <br /> angles, the KS-PS differentiates particles that are not repre- <br /> sentative of actual smoke. Data is digitally filtered to <br /> remove signal patterns that are typical of nuisance sources, <br /> thus reducing unwanted alarms. To make an alarm deci- <br /> sion, the detector's on-board microprocessor measures �� <br /> and analyzes all optical sensor readings and compares this <br /> information to a preprogrammed setting. <br /> ADDRESSING <br /> KS-PS detectors feature electronic addressing. No addressing INSTALLATION <br /> switches are used. A KS-PS detector mounts to North American 1-gang boxes, 3-1/2 <br /> inch or 4 inch octagon boxes, and to 4 inch square electrical <br /> PROTOCOL boxes 1-1/2 inches(38 mm)deep. <br /> This product will operate only on a Kidde Fire Systems fire alarm- EASY TWIST HEAD <br /> suppression control unit employing SmartOne communications <br /> protocol. A KS-PS detector head is installed onto its base by aligning arrow <br /> marks and gently twisting the head clockwise until secure. <br /> STATUS LED Removal is just as easy and is done by grasping the head and <br /> KS-PS detectors use an LED to indicate the detector's condition. gently pressing down while turning counter-clockwise. Removal <br /> In normal, standby condition, a green LED flashes at a 9 second can be aided with the optional SIGA Removal Tool (P/N SIGA- <br /> repetition rate. An alarm is indicated by a red flash at a 2.50 sec- RTA). This tool can be attached to a telescoping pole to avoid the <br /> and repetition rate. use of ladders. <br /> REMOTE ALARM LED SENSITIVITY <br /> An optional SIGA-LED Remote Indicator can be connected to the The alarm sensitivity is the minimum obscuration level at which <br /> standard DS-SB base if the KS-PS detector status LED is in a the detector initiates an alarm condition and can be specified via <br /> location where it cannot be easily viewed. the control unit menus or the remote configuration software. The <br /> control unit to which the detectors are connected is capable of <br /> interrogating each detector to determine its sensitivity. <br />