Laserfiche WebLink
VERETT <br />0 <br />Permit Inspections <br />City of Everett <br />9/9/2022 <br />9/9/2022 <br />PLUMB 08-FINAL <br />JASON <br />CORRECTION <br />eTRAKiT Inspection Request <br />MORRISSEY <br />REQUIRED <br />Notes: <br />8/29/2022 11:28 PM Jiayi Shen <br />Contact Name: Jiayi Shen <br />Site Address: 2308 TAYLOR DR <br />Phone:4255315919 <br />e-Mail: jiayi.shen@hotmail.com <br />- Install approved air -gap fitting on kitchen sink for DW drain per UPC 807.3 Domestic Dishwashing MachineNo domestic dishwashing machine shall be <br />directly connected to a drainage system or food waste disposer without the use of an approved dishwasher air gap fitting on the discharge side of the <br />dishwashing machine. Listed air gaps shall be installed with the flood -level (FL) marking at or above the flood level of the sink or drainboard, whichever <br />is higher. - Install dual shut off angle stop on hot supply under kitchen sink per UPC 606.5 Control Valve each water supplied appliance needs separate <br />shut off valve.- Install smooth walled pipe for tubular waste under kitchen sink per UPC.- Only one slip joint connection can be used on the outlet side <br />off the trap per UPC. (Under kitchen sink) 1003.2 Slip Joint Fittings. <br />9/13/2022 <br />9/13/2022 <br />PLUMB 08-FINAL <br />JASON <br />CORRECTION <br />eTRAKiT Inspection Request <br />MORRISSEY <br />REQUIRED <br />Notes: <br />9/11/2022 10:19 PM Jiayi Shen <br />Contact Name: Jiayi Shen <br />Site Address: 2308 TAYLOR DR <br />Phone:4255315919 <br />e-Mail: jiayi.shen@hotmail.com <br />- Replace corrugated back graded tubing on gravity side of airgap with approved 7/8" dishwasher drain hose. Grade down hill to disposal connection. <br />9/14/2022 <br />9/14/2022 <br />PLUMB 08 FINAL <br />JASON <br />APPRVD-PERMIT <br />eTRAKiT Inspection Request <br />FINALSON <br />Notes: <br />9/13/2022 4:50 PM Jiayi Shen <br />Contact Name: Jiayi Shen <br />Site Address: 2308 TAYLOR DR <br />Phone:4255315919 <br />e-Mail: jiayi.shen@hotmail.com <br />I <br />Printed: Friday, 20 October, 2023 3 of 3 rk <br />SUPERION <br />