Laserfiche WebLink
Insulation Certificate for Residential New Construction <br />Permit #: I <br />House addres or lot number: Harrison Lot 12 Unit N- 9502 18th Ave W <br />Walls ' <br />Type of insulation: Fiberglass <br />Manufacturer: O.C. <br />R-Value: 21 <br />Floor <br />Type of insulation: Fiberglass <br />Manufacturer: O.C. <br />R-Value: 38 <br />Flat Ceiling/ Attic <br />Type of insulation: Fiberglass <br />Manufacturer: O.C. <br />R-Value: 49 <br />Single Rafter <br />Type of insulat <br />Manufacturer: <br />R-Value: <br />st Vaulted Ceiling <br />Insulation Installer: <br />Company Na <br />Signature: <br />Phone Num <br />Washington State <br />R303.1 Identificatioi <br />303.1.1 Building <br />Sul <br />31 <br />Blown or Sprayed Fiberglass or Cellulose — Walls <br />R-Value per Inch: <br />Coverage Area: <br />Bag Count: <br />Blown or Sprayed Fiberglass or Cellulose — Ceiling <br />R-Value per Inch: 3.3 <br />Coverage Area: <br />Bag Count: <br />Sprayed Polyurethane Foam (SPF) <br />Density: <br />Installed Thickness: <br />R-Value of Installed Thickness: <br />Building Component Installed: walls floor ceiling <br />Admin: Stesha Kirk <br />Date: 3.13.24 <br />inergy Code Reference http://www.energy.wstj.edu Documents 2012%20Res%ZOEnergy.pdf <br />Materials, systerns and equipment shall be identified in a manner that will allow a determination of compliance with the <br />applicable provisions of this code, <br />nal envelope insulation. An R value identification mark shall be applied by the manufacturer to each piece of building thermal <br />envelope insulation 12 inches (305 mm) or greater width. Alternately, the insulation installers shall provide a certification listing the <br />type, manufacturer and R-value of insulation installed in each element of the building thermal envelope. For blown or sprayed <br />Insulation (fiberglass and cellulose), the initial installed thickness, settled thickness, settled R-value, insulation density, coverage area <br />and number of bags installed shall be listed on the certification. For sprayed polyurethane foam (SPF) insulation, the installed <br />thickness of the areas covered and R-Value of installed thickness shall be listed on the certification. The insulation installer shall <br />sigh, date and post certification in a conspicuous location on the job site. <br />