10030 DAKOTA WAY 2023-12-07 - Laserfiche WebLink

•Tabjung Lee1.7 Plan Check Number: B2205-001., First Building Review September 8, 2022 c. ,'die floor may result in a vertical clearance that is less than 7 feet as required by Section R:305.1. The minimum required height should be maintained and specified in the drawings. Ceiling height 7ft min. See note on floor plan Pantry & Den See eisrnic restraints should be specified for the water heater per SectionMU:307.2. note on floor plan 9.he project includes exposing the exterior envelope cavities for the entire building. The building is required to be insulated per WSEC Section R503.1.1. The minimum required thermal rating for the exterior walls is R-15. See typical wall section on sheet 4 10.The project includes replacement of some of the existing windows and exterior doors as observed in recent electrical inspection photography, including but not limited to the Master Bedroom window and IPanty/Garage door. The required thermal ratings for each type of vertical fenestration should be specified. See WSEC Table R402.1.1. See note on floor plan Structural 1. The project involves removing walls that are or may be load bearing, including but not limited to the center wall in the garage and the walls to convert the second bedroom into a Master Bathroom and jeloset. Roof and floor framing and foundation plans showing the modified load paths are required. The modified load paths should comply with the prescriptive limitations of the IRC. Alternatively, an engineered analysis and design may be performed per Section R301.1.3; sealed and signed drawings and calculations prepared by a professional engineer licensed in the state of Washington are required per RCW 18.43.010, 18.43.020, and 18.43.070. See Section R301.1. The interior wall partition to be removed is a non-load bearing wall. Details for the construction of the new walls should be included. The details should specify connections for the top and bottom framing plates to the existing structure. The details should include headers (e.g., garage wall supporting roof, etc.). See Sections R106.1.1, R301.1, R602.4, and R602.7. New interior partition to have 2x4 studs @ 16"o.c. with double top plates lap splices at 48 inches and 2x4 bottom plate. See typical wall section on sheet 4 3. The project appears to include a new raised floor system in the Pantry/Den area of the house. Note /hat there is, a new step between the Pantry and Garage. No raises floor system is currently p-esent as documented by recent electrical inspection photography. The floor construction should be shown. See Sections R106.1.1, R318, and Chapter 5, and architectural comments above. No new raised floor to install at Pantry and Garage. See floor plan ,,A. Details for tie construction of landings, stairs, and ramps for the egress route should be included in the construction drawings. See Section R106.1.1 and architectural comments above. There is an existing concrete steps at egress route and there is no ramp. See floor plan at entry living room (-O3200 Cedar Street © 425.257.8810 O everetteps@everettwa.gov ---) Everett,WA 98201 425.257.8857 fax everettwa.gov/permits Page 2 of 2