1410 SEINER DR 2024-04-12 - Laserfiche WebLink

DN-6999:E Monitor Modules ® NOTIFIER NM -i 00(A), NMM-100P(A), NZM-100(A), an NDM-100 A) for FireWarden Series by Honeywell Intelligent Addressable Devices General Four different monitor modules are available for Notifier's FireWarden Series intelligent control panels for a variety of • " applications. Monitor modules supervise a circuit of dry-con- ` tact input devices, such as conventional heat detectors and ® } pull stations, or monitor and power a circuit of two-wire ° d ale , smoke detectors(NZM-100(A)). COMIM NMM-100(A)is a standard-sized module(typically mounts to K Fs a 4" [10.16 cm] square box)that supervises either a Style D " 3 , (Class A) or Style B (Class B) circuit of dry-contact input g devices. -,....° NMM-100P(A) is a miniature monitor module a mere 1.3" (3.302 cm)H x 2.75"(6.985 cm)W x 0.65"(1.651 cm)D that supervises a Style B (Class B) circuit of dry-contact input devices. Its compact design allows the NMM-100P(A) to be " "M mounted in a single-gang box behind the device it monitors. NZM-100(A) is a standard-sized module that monitors and ° supervises compatible two-wire, 24 volt,smoke detectors on a Style D(Class A)or Style B(Class B)circuit. NMM-100(A)(Type H) NDM-100(A) is a standard-sized dual monitor module that monitors and supervises two independent two-wire Style B to monitor normally-open supervisory devices with special (Class B) dry-contact initiating device circuits (IDCs) at two supervisory indication at the control panel. Monitored circuit separate, consecutive addresses in intelligent, two-wire sys- may be wired as an NFPA Style B(Class B)or Style D(Class tems. A)Initiating Device Circuit.A 47K Ohm End-of-Line Resistor LiteSpeedTM is a communication protocol that greatly (provided) terminates the Style B circuit. No resistor is increases the speed of communication between analog Intel- required for supervision of the Style D circuit. ligent devices. Intelligent devices communicate in a grouped NMM-100(A)OPERATION fashion. If one of the devices within the group has new infor- mation,the panel CPU stops the group poll and concentrates Each NMM-100(A) uses one of the available module on single points. The net effect is response speed greater addresses on an SLC loop. It responds to regular polls from than five times that of other communication protocols. the control panel and reports its type and the status (open/ normal/short)of its Initiating Device Circuit(IDC).A flashing NMM-100[A) Monitor Module LED indicates that the module is in communication with the control panel. The LED latches steady on alarm (subject to • Built-in type identification automatically identifies this current limitations on the loop). device as a monitor module to the control panel. NMM-100(A)SPECIFICATIONS • Powered directly by two-wire SLC loop. No additional power required. Nominal operating voltage: 15 to 32 VDC. • High noise(EMF/RFI)immunity. Maximum current draw:5.0 mA(LED on). • SEMS screws with clamping plates for ease of wiring. Average operating current: 375 pA(LED flashing), 1 com- • Direct-dial entry of address: 01 —99 on FireWarden-100- munication every 5 seconds,47k EOL. 2,01—50 on FireWarden-50. Maximum IDC wiring resistance: 1500 Ohms. • LED flashes during normal operation and latches on Maximum IDC Voltage: 11 Volts. steady to indicate alarm. The NMM-100(A)Monitor Module is intended for use in Intel- EOL resistance:47K Ohms. ligent, two-wire systems, where the individual address of Temperature range:32°F to 120°F(0°C to 49°C). each module is selected using the built-in rotary switches. It provides either a two-wire or four-wire fault-tolerant Initiating Humidity range: 10%to 93%noncondensing. Device Circuit(IDC)for normally-open-contact fire alarm and Dimensions: 4.5" (11.43 cm) high x 4" (10.16 cm) wide x supervisory devices.The module has a panel-controlled LED 1.25" (3.175 cm)deep. Mounts to a 4" (10.16 cm)square x indicator. 2.125"(5.398 cm)deep box. NMM-100(A)APPLICATIONS Use to monitor a zone of four-wire smoke detectors, manual NMM-100P(A) Mini Monitor Module fire alarm pull stations,waterflow devices, or other normally- • Built-in type identification automatically identifies this open dry-contact alarm activation devices.May also be used device as a monitor module to the panel. DN-6999:E•07/30/2015—Page 1 of 4