1130 SE EVERETT MALL WAY MATTRESS FIRM 2024-04-02

• • 4 A" StarLink SLE-LTEV-CFB-PS NAPCO SLE-LTEV-CFB INTRODUCTION Commercial / Residential Fire The StarLink"Commercial/Residential Fire and Burglary alarm capture radio communicators are fully supervised,wireless digi- and Burglary Series Alarm tal two-way subscriber units supported by an extensive nation- wide wireless network. All models are compatible with most Communicators 12VDC alarm control panels (always adhere to the documenta- tion provided by the control panel manufacturer). Model SLE- Submittal Data Sheet LTEV-CFB is compatible with most 12 or 24VDC control panels. All can function as a backup to existing telephone lines, or as sole path primary communicators. In backup mode, all units SLE-LTEV-CFB-PS: Commercial/Residential Fire and Burglary will automatically switch the communication channel from the Radio in red metal housing with SLE-ULPS-R power supply and telephone line to the network when telephone line trouble is 16.5V/20VA transformer mounted inside housing detected. See WI2140 for programming information. The SLE-LTE Series radios use data-capture technology that cap- SLE-LTEV-CFB: Commercial / Residential Fire tures the alarm report from the control panel and transmits the and Burglary in red metal housing. Powered alarm signals to the SLE Control Center; the alarm signals are directly from control panel (no power supply, no then forwarded to ANY central station via Contact ID or Sur- transformer,rated 12/24VDC input) Gard System II via TCP/IP using standard line security. The SLE Control Center reports a trouble signal in the event that the network does not receive the expected supervision signal from the wireless communicator. For Commercial Burglary installations,under the armed condi- tion,any loss of communication must be treated as a Burglary Stir Alarm at the Central Station. STARLINK RADIO REPORTING PATH The diagram below shows the transmission path of a FIRE ALARM COMPATABILITY signal from the StarLink radio to the central station. These StarLink LTE Series models are compatible with most 12VDC 1.Signal from a Control Panel. alarm control panels equipped with a DACT that must transmit 2.StarLink radio receives the signal transmission (from central station reports in Contact ID or 4/2 central station formats. the TIP an RING wires); sends RF signal through the The control panel may also trigger communication events through GPRS network operator. the use of FACP dry contacts connecting the(3)radio inputs,capa- 3.Network Operator, part of the vendor system, a ble of transmitting (4) distinct alarm and trouble event reports to section of the cellular spectrum. the central station. The following features are included with mod- 4.SLE Network Operations Center, receives/routes data. els that include a SLE-ULPS-R power supply: 5.Central Station. • Power limited output to the StarLink radio PC board 12V input terminals iRFl��j • Battery connection red and black flying leads �a • Monitored battery charging and Active battery test circuits ((��" ' i))�� • StarLink radio trouble input (from StarLink radio PC board StarLink ' PGM1 terminal to detect StarLink radio trouble) Radio t •• Requires a sealed lead acid min 4AH/max 7AH battery for min - A 2) :is imum 24-hour standby time(max charge current 200mA). FACP — (3) A1/A. • Trouble relay output(C, N/O and N/C terminals)to wire to a (1) Network panel zone dedicated to"LTE Trouble" (dry contacts). Remove Operator jumper"J2"to isolate common from ground 1,I / • Green AC ON LED visible from the exterior housing i� • Yellow TROUBLE LED on PC board. Flashes signify: One flash: AC fail/brownout(2 hour delay) r—' Two flashes: Low battery CENTRAL �5� I��) (4) Three flashes: Charging circuit trouble STATION StarLink Network Four flashes: StarLink radio trouble Operations Center NAPCO Security Technologies,Inc.,333 Bayview Ave,Amityville,NY 11701 (800)645-9445;Fax(631)789-9292 A733 11/18 \8\ b ) II