1130 SE EVERETT MALL WAY MATTRESS FIRM 2024-04-02

• • The housing-mounted transformer (when provided) is mounted inside its own housing compartment with a replaceable UL • Input Current:150mA maximum Listed .5A fast blow primary fuse. 120VAC connections are to be • Maximum Charging Current: 200mA made by a licensed electrician using suitable connectors,in accord- Electrical Ratings for+12V ance with N.E.C.and local code requirements. For Models without Power Supply* • Input Voltage: 10-15VDC (power-limited output from Listed ADDITIONAL COMPONENTS control panel). Note: Model SLE-LTEV-CFB is rated 10-25VDC input. In addition to the models listed above, the following sub- • Input Current for SLE-LTEV-CFB: 10V=90mA, 12V = 71mA, assemblies are available: 25V=68mA,with peak RF transmission current of 200mA. SLE-ULPS-R - Power Supply. Required for installations where the Electrical Ratings for the IN 1 Burg/Fire Input: control panel cannot provide the 71mA of Auxiliary power re • Input Voltage: 9-15VDC. Note: Model SLE-LTEV-CFB is rated quired to operate the StarLink radio. Uses a standard 4AH/12V minimum(7AH maximum)rechargeable battery to provide radio 9-25VDC input. standby power. Requires connection to either the model NAP- • Maximum Input Current: Up to 2mA from FACP NAC circuit CO TRF12/T123 (16.5V/20VA) external plug-in transformer or Electrical Ratings for IN 2 and IN 3: the chassis-mounted 16.5VAC/20VA transformer affixed inside • Maximum Loop Voltage: 15VDC. Note: Model SLE-LTEV-CFB the housing(see wiring diagrams further in this manual). Note: is rated max 25VDC input. For models without the SLE-ULPS-R,connect the radio terminals • Maximum Loop Current: 1.2mA 1 and 2 to the control panel Aux Power terminals (observing • End of Line Resistor(EOLR)Value: 10K(2 req'd) polarity). Electrical Ratings for 3 PGM Outputs: SLE-DLCBL- Download Cable,6 feet • Open Collector Outputs: Maximum Voltage 3V when active; SLE-ANTEXT30-Extended antenna with 30 feet of cable 15V maximum when not active. Note: Model SLE-LTEV-CFB is SLE-ANTEXT50-Extended antenna with 50 feet of cable rated max 25VDC output. SLE-ANTEXT75-Extended antenna with 75 feet of cable • Maximum PGM Sink Current: 50mA (up to 15VDC), 25mA (Any suitable external cellular antenna is permitted by UL). Al- (15.1VDC-25VDC) ways follow the manufacturer's installation instructions. Note: Physical(W x H x D) Antennas are not Listed by UL. For LTE radios where an External • Metal Housing: 111A x 9%:x 31/2'(29.2 x 24.1 x 8.9cm) Antenna needs to be installed outside of the room in which the • Mounting: Metal housing includes two keyhole slots for wall radio is installed (maximum 30 meters (98 feet) in Residential mounting applications), please use RF Transmitter Board 9SLELTEEXAPSLD available from our Customer Service Department, if not provid Environmental ed. The 9SLELTEEXAPSLD is identified by"two red dots"located • Operating Temperature: 0°C 49°C(32°F 120°F) on the lower right corner of the board. See WI2239 included • Humidity: Maximum 93%Non Condensing with the 9SLELTEEXAPSLD for the simple installation procedure. • Indoor/dry location use only GEM-Tamperkit -Tamper switches and screws to protect metal housing AGENCY LISTINGS SPECIFICATIONS • UL 864 Standard For Control Units and Accessories For Fire Alarm The following specifications apply to all StarLink radio models Systems,10th Edition • UL 1610 Standard For Central-Station Burglar-Alarm Units unless otherwise stated: • UL 985 Standard For Household Fire Warning System Units Electrical Ratings for 120VAC,60Hz • UL 1023 Standard For Household Burglar-Alarm System Units For Models with Power Supply • Input Voltage: 120VAC nominal LTEV models are Verizon Network Certified NOTICE TO AUTHORITIES HAVING JURISDICTION, USERS, INSTALLERS, DEALERS, AND OTHER AFFECTED PARTIES FIRE PROGRAMMING OPTION PERMITTED IN AVAILABLE SETTINGS REQUIRED UL 864 SETTINGS UL864?(YIN) Disabled(Jumper 1 installed). Also required for Commercial/Burglary Unattended Remote Downloading No Enable/Disable installations. Note: See the Installation Instructions section "Configuration Download I Firmware Updates"for jumper instructions. IN2 and IN3 Unsupervised No Supervised/Unsuper- Supervised(Jumpers 4 and 5 installed) vised Radio Path Supervision No 200 seconds,5 minutes, 200 seconds(UL 864/UL 1610),5 minutes(UL 864 9th edition),60 60 minutes,7 days minutes(UL 864 10th edition),7 days(UL 985/UL 1023) *For Commercial Fire installations,a UL Listed Fire Alarm regulated power supply or FACP regulated auxiliary output is required. \ ill\