Laserfiche WebLink
NDE: ULTRASONIC TESTING INSPECTION REPORT MAYES I lrerracon <br /> Report Number: M7221502.0011 <br /> Service Date: 11/10/22 20225 Cedar Valley Rd Ste 110 <br /> Report Date: 11/11/22 Lynnwood,WA 98036-6365 <br /> 425-742-9360 <br /> Client Project <br /> The Boeing Company Boeing Everett 45-04 Paint Hangar Wing Stands <br /> Attn: Mark Gosnold 2451 100th St SW <br /> PO BOX 3707 Everett,WA <br /> Seattle, WA 98124-2207 <br /> Project Number: M7221502 <br /> Permit No.:Not Applicable <br /> GENERAL INFORMATION <br /> Mayes Terracon performed inspection of fit-up on the air damper support steel in Building 45-04 for the replacement of new <br /> ventilation dampers. <br /> Structural drawing M597 showed the basic layout pattern for the new damper support HSS steel sections. <br /> The damper structural frames were located in the Upper Level Fan Rooms of Building 45-04. <br /> Inspection found the fit-up of the second course of two courses in compliance with the structural drawings with the following <br /> exception. <br /> The last HSS member in the upper and lower courses on the west end was short. This caused an excessive gap between <br /> the horizontal member and the vertical member(see photo). <br /> 111 3/4"=Gap <br /> "i <br /> This gap was at least 3/4" and will not provide sufficient contact for an approved fillet weld. This condition will require review <br /> by the design engineer for an acceptable correction. <br /> Inspection found the fit-up of the remaining weld joints in compliance with the construction drawings and weld procedures. <br /> Visual inspection was performed on the final welding of four HSS members in the first course located east of center. <br /> The tests were performed in general accordance with applicable ASTM,AASHTO,or DOT test methods. This report is exclusively for the use of the client <br /> indicated above and shall not be reproduced except in full without the written consent of our company. Test results transmitted herein are only applicable to <br /> the actual samples tested at the location(s)referenced and are not necessarily indicative of the properties of other apparently similar or identical materials. <br /> CT0001,10-16-13,Rev.10 Page 1 of 2 <br />