Laserfiche WebLink
NDE: ULTRASONIC TESTING INSPECTION REPORT MAYES I lrerracon <br /> Report Number: M7221502.0011 <br /> Service Date: 11/10/22 20225 Cedar Valley Rd Ste 110 <br /> Report Date: 11/11/22 Lynnwood,WA 98036-6365 <br /> 425-742-9360 <br /> Client Project <br /> The Boeing Company Boeing Everett 45-04 Paint Hangar Wing Stands <br /> Attn: Mark Gosnold 2451 100th St SW <br /> PO BOX 3707 Everett,WA <br /> Seattle, WA 98124-2207 <br /> Project Number: M7221502 <br /> UMC contractor informed Inspection that the existing conditions would not allow for welding the horizontal HSS members on <br /> four sides. UMC/Skanska submitted and RFI 100 that approved welding these members on three sides. <br /> Inspection found these welds in compliance with the structural drawings, RFI 100 and AWS D1.1. <br /> COMPLIANCE STATEMENT <br /> Nonconforming Condition(s) <br /> The last HSS member in the upper and lower courses on the west end was short causing an excessive gap between the <br /> horizontal member and the vertical member. <br /> Services: Special Inspections/Materials Testing <br /> Mayes/Terracon Rep.: Michael Virgilio <br /> Reported To: Skanska USA Building Inc <br /> Contractor: Skanska <br /> Report Distribution: <br /> See attached distribution list. <br /> Reviewed By: <br /> Barry Tuttle <br /> Project Field Manager <br /> The tests were performed in general accordance with applicable ASTM,AASHTO,or DOT test methods. This report is exclusively for the use of the client <br /> indicated above and shall not be reproduced except in full without the written consent of our company. Test results transmitted herein are only applicable to <br /> the actual samples tested at the location(s)referenced and are not necessarily indicative of the properties of other apparently similar or identical materials. <br /> CT0001,10-16-13,Rev.10 Page 2 of 2 <br />