Laserfiche WebLink
COUPLINGS <br />AIMM <br />FIG. 7402 <br />slideLOK° Ready for Installation Coupling <br />REINSTALLATION OF THE FIGURE 7402 SLIDELOKTm COUPLING <br />The SlldeLOK coupling Is designed to be Installed In the ready for Installation assembly position once. After the Initial assemble the following steps are to <br />betaken to re install the Flg. 7402 SlideLOK coupling. <br />1De-pressurize the <br />System— Depressurize <br />the system before removing the <br />SlideLOK Coupling. Dlsassemble <br />the couplings by removing the nuts, <br />bolts and gasket from the housing <br />halves. A wrench Is required to <br />overcome the epoxy used to <br />secure the nuts on the bolts. <br />2Pipe Preparation <br />Pipe ends areto be rolled or <br />cut grooved accord Ing to Anvil <br />specifications Not for use on'EG" <br />rolled or aR grooved pipe ends <br />The pipe end must be smooth and <br />free from metal burrs or <br />projections <br />3 Gasket Preparation <br />Ensure the gasket is suitable <br />for the Intended application by <br />referring to the Anvil gasket <br />compatib IOty chart. A light mating <br />of Gruvlokx XTrem e"lubricant <br />must be applied to the gasket <br />prior to Installation. <br />4Pipe Alignment and <br />Gasket Installation <br />Slide the gasket onto the pipe <br />then align the two pipe ends <br />together Pull the gasket into <br />position, centering It between the <br />grooves on each pipe. Gasket <br />should not extend into the groove <br />on eltherplpe <br />5 Housing Assembly <br />Place each housing halves on <br />the pipe making sure the housing <br />key fits Into the groove Be sure <br />that the tongue and recess <br />portions of the housing mate <br />properly, Insert the bolts. <br />6 Final Assembly <br />The SlideLOK is <br />7FinalInspection 1: <br />Ensure the is I <br />coupling <br />coupling <br />designed to achieve pad to <br />properly aligned In the <br />pad (metal -to -metal contact) <br />grooves and the housing <br />using either an Impact <br />44 <br />halves are In metal tometal <br />wrench* or wrench. The <br />contact, depicted In the <br />Intended torque range for the <br />pictures to the right <br />coupling is located In the <br />Table 1. Semrelytlghten nuts <br />•' <br />alternately and equally until <br />S,i Torque <br />the housing halves are In <br />rx vum <br />metal to metal contact <br />2-4 80-100 <br />5-6 100-130 <br />8 130-180 <br />*CAUTION:WM1enusing an lmpaR wench write that Me output of Me imlect werch is <br />within Me required Lorene mnye. it Is recomianded that a Lorene wend, Musedfor <br />,reassembly In order to obtain slashed pedornsance <br />Inco— - 'xamples <br />�J <br />Low Torque or Out of Excess Torque or Shallow <br />Groove Groove Dimension <br />SIT 516 <br />