3201 SMITH AVE BASE FILE 2024-10-14

4V SimplEx TrueAlarm Analog Sensors- Photoelectric and Heat; Standard Bases and Accessories Sensor Bases 4098-9792,Standard Sensor Base 4098-9789,Sensor Base with wired connections for: • 2098-9808 Remote LED alarm indicator or 4098-9822 relay(relay is unsupervised and requires separate 24 VDC) Supervised Relay Bases(not compatible with 2120 CDT): 4098-9791,4-Wire Sensor Base,use with remote or locally mounted 2098-9737 relay,requires separate 24 VDC 4098-9780,2-Wire Sensor Base,use with remote or locally mounted 4098-9860 relay,no separate power required Supervised relay operation is programmable and can be manually operated from control panel Includes wired connections for remote LED alarm indicator or 4098-9822 relay(relay is unsupervised and requires separate 24 VDC) Sensor Base Options 2098-9737,Remote or local mount supervised relay: DPDT contacts for resistive/suppressed loads,power limited rating of 3 A @ 28 VDC;non-power limited rating of 3 A @ 120 VAC(requires external 24 VDC coil power) 4098-9860,Remote or local mount supervised relay: ALARM • SPDT dry contacts,power limited rating of 2 A @ 30 VDC,resistive;non-power limited rating of 0.5 A @ 125 VAC,resistive 4098-9822,LED Annunciation Relay: •Activates when base LED is on steady,indicating local alarm or trouble • DPDT contacts for resistive/suppressed loads,power limited rating of 2 A @ 28 VDC;non-power limited rating of 1/2 A @ gSi"ple" 120 VAC,(requires external 24 VDC coil power) 4098-9832,Adapter plate: • Required for surface or semi-flush mounting to 4"square electrical box and for surface mounting to 4"octagonal box • Can be used for cosmetic retrofitting to existing 6-3/8"diameter base product Figure 2: Remote 2098-9808,Remote red led Alarm Indicator: red LED Alarm • Mounts on single gang box(shown in illustration) Indicator Description TrueAlarm sensor bases contain integral addressable electronics that constantly monitor the status of the detachable photoelectric or heat sensors. Each sensor's output is digitized and transmitted to the system fire alarm control panel every four seconds. Since TrueAlarm sensors use the same base,different sensor types can be easily interchanged to meet specific location requirements.This feature also allows intentional sensor substitution during building construction.When conditions are temporarily dusty,instead of covering the smoke sensors (causing them to be disabled),heat sensors may be installed without reprogramming the control panel.Although the control panel will indicate an incorrect sensor type,the heat sensor will operate at a default sensitivity providing heat detection for building protection at that location. Features Sealed against rear air flow entry Interchangeable mounting EMI/RFI shielded electronics Heat sensors: Selectable rate compensated,fixed temperature sensing with or without rate-of-rise operation Rated spacing distance between sensors: Fixed Temp.Setting UL&ULC Spacing IFM Spacing,Either Fixed Temperature Setting 135°F(57.2°C) 60 ft x 60 ft(18.3 m) 20 ft x 20 ft(6.1 m)for fixed temperature only;RTI=Quick 155-F(68°C) 40 ft x 40 ft(12.2 m) 50 ft x 50 ft(15.2 m)for fixed temperature with either rate-of-rise selection;RTI::1 = Ultra Fast Note:*1900 F(880 C)ratings apply only to the 4098-9734 sensor. Smoke Sensors: Photoelectric technology sensing 360'smoke entry for optimum response Built-in insect screens Page 2 54098-0019 Rev.25 01/2020