7000 HARDESON RD 2024-12-30 - Laserfiche WebLink

Confidential Draft Hydrogen Fueling Station Performance Validation Testing—DO NOT CITE OR QUOTE HyStEP Summary Test Report for Linde—Mobile Refueler Hydrogen Station Updated Revision Date:September 27,2023 V. General Fault Detection Tests Summary Test Comment Pass Fail E-stop ® ❑ Confirmed hydrogen station and dispenser shutdown. E-Customer Stop ® ❑ Confirmed fueling terminated. CHSS Capacity Range. ® ❑ Before initiating fueling,TV was set to 45 L and 250 L on hystep. Dispenser Note:Performed in communication terminated fueling after connection pulse with code"25". Ambient Temperature. ® ❑ Before initiating fueling,station operator applied offset to ambient temperature sensors in the PLC so that Tamb=-41.5 C and 51.5 C.Fueling did not begin with codes'temp_too_low'and'temp_too_high'respectively. Minimum Fuel Delivery Temperature. ® ❑ During fueling,station operator applied offset to fuel temperature sensors in the PLC,causing Tfuel=-43C.Dispenser terminated fueling immediately. Ambient Temperature Limits for Station operator simulates ambient temperature inputs in the PLC before Ambient Fueling- Tamb>Tfuel+5C; ® ❑ start:Tamb>Tfuel+5C;Tamb<Tfuel—5C Tamb<Tfuel—5C Fuel Delivery Temperature Tolerance During fueling,station operator simulates ambient temperature inputs in the for Ambient Fueling-Tfuel<Tamb— ® ❑ PLC: Tfuel<Tamb—5C;Tfuel>Tamb+5C 5C;Tfuel>Tamb+5C Maximum CHSS Gas Temperature. ® ❑ During fueling after 30 sec main fueling time,MT was set to 360 K on hystep. Dispenser terminated immediately with code"19"'vehicle tempt.out of boundary'. Minimum CHSS Initial Pressure. NOT APPLICABLE Non-Communication fills:station only fills in Note:Performed only in communication ❑ ❑ communication mode,for more details see executive summary#10. (station does not fuel in non- communication mode)when pressure is H70 Communication passed.Before initiating fueling MP was set to 1.5 MPa <2 MPa. ® ❑ on hystep. Dispenser terminated fill after connection pulse. Maximum CHSS Initial Pressure. ® ❑ In communication mode with CHSS pressure of 38.0 MPa,dispenser did not start with code'CHSS pressure over limit". Maximum CHSS Pressure(with ® ❑ During fueling after 30 sec main fueling time, MP was set to 44 MPa on communication). hystep.Dispenser terminated immediately with code'12'"J2601 POS criteria met". Maximum State of Charge(SOC). ® ❑ During fueling after 30 sec main fueling time,MT was set to 243 K on hystep Note:Performed in Communication @ P=30 MPa. Dispenser terminated immediately with code"12"J2601 POS criteria met. (MT value was calculated using MT=PO*3.76+20.7-5) Lower pressure corridor limit Confirmed during an actual test(Max.CHSS Gas Tempt)when dispenser Run in communication or non- ® ❑ stopped due to a lower pressure corridor limit fault,with code"18""lower communication mode. limit boundary failure". Upper pressure corridor limit Confirmed during an actual test(Max.CHSS Gas Tempt)when dispenser Run in communication or non- ® ❑ stopped due to an upper pressure corridor limit fault,with code"upper limit communication mode. boundary failure". 12 Page 21 of 38