2000 HEWITT AVE EVERETT EVENT CENTER 2024-12-31

5.1.1.4 Deactivating single angles The X2 Wave-Flamer makes it possible to block certain angles before the show, so they cannot be driven to.This allows you to reduce any risk of damaging objects in certain angles beforehand. 5.1.1.5 Turning armed The device can be turned armed by radio signal.Therefore, it is not necessary for any persons to linger in the devices vicinity to activate it. Only after the device has been turned armed, will the pressure be built up.The pressure is constantly checked. 5.1.1.6 Power outage In case of a power outage,the Device will cancel a currently running Sequence. After turning it on again, it will start the usual starting tests. 5.2 Safety hints The following Safety hints must not necessarily obeyed, but should be followed if possible. 5.2.1 Emergency stop button It is recommended to power the devices via a 230VAC power grid, and install an emergency stop button into the power cable,to make it possible to turn the device off at anytime. 5.2.2 Drip pan If the device is placed atop flammable material, or the floor must be protected, we recommend the use of a drip pan, to be placed underneath the device. The pan should collect any leaking fluids, and protect the floor. The pan should measure at least 60x40 cm with a depth of5cm. 5.2.3 Collection canister An alternative to the drip pan is a collection canister, into which the plastic canister is placed when filled. Such a Stainless Steel canister will be available as an accessory in the future. 5.2.4 Abort an Autoshow To abort an Autoshow, the Flamer must receive a Pause-, Disarmed-, or Test Signal. During a predefined sequence however, no signals will be received. To ensure complete safety, you should send Test signals until the flamer no longer ignites and/or lower the Timeout (see 3.2.6). 5.3 Safety notes The device may only be used when it is in maintained and working condition. Faulty devices must be checked and repaired by the manufacturer, or an official service person. Under no circumstances must faulty devices be used. After longer storage, the devices should be checked for function, and leaktightness.