Laserfiche WebLink
4.3.1.6 Channel 6:Mode(Starting address+5) <br /> The sixth DMX channel is the Handling Mode. It allows you to set the device into Armed-Mode (DMX- <br /> value 50 to 200). The other DMX values are the Test-Mode. Important: The device can only make <br /> ignitions in Armed-Mode. <br /> Mode <br /> DMX-Value 0 to 49 50 to 200 201 to 255 <br /> Mode Test-Mode Armed-Mode Test-Mode <br /> 4.3.2 Steps to use the device with DMX-protocol <br /> 1. Set angle to 0°for safety reasons (Channel 1 to DMX-value 128) <br /> 2. Turn device Armed (Channel 6 to DMX value 50 to 200) <br /> 3. Select opening time of ignition or sequence ( Channel 4 or channel5) <br /> 4. Select angle (Channel 1) <br /> 5. Activate ignition (Channel 3 to DMX value 254 or 255) <br /> 6. Deactivate ignition (Channel 3 to DMX value below 254) <br /> Note: When using sequences, do not activate Sequences and ignitions at the same time. First <br /> choose a sequence,then make an ignition 40ms later <br /> In rare cases the Flamer might not ignite otherwise. <br /> The X2 Wave-Flamer has many safety functions that protect the device from damages, and allow the <br /> user to make special safety preparations to avoid personal or property damage. You should follow all <br /> instructions set in chapter5.3. <br /> 5.1 Safety functions <br /> 5.1.1.1 Double solenoid valve <br /> The device features to serial solenoid valves. Besides the standard Flame valve, an extra safety valve <br /> has been built into the device. Without electrical ignition,the valves cannotopen. <br /> 5.1.1.2 Mechanical Stop <br /> A mechanical stop in both movement directions hinders the device from reaching any angles over <br /> 120° in both directions. <br /> 5.1.1.3 Automatic Safety tests <br /> Automated safety tests after switching on the device, as well as while it's running,test the system for <br /> a variety of errors. For example, a test is made whether the moving head is blocked in any way <br /> (Drivetest), or if the system has a leak. <br />