Laserfiche WebLink
Non-Seismic Lifts: NOTE: Use rectangular <br /> Drill 3/4" dia.holes in concrete floor using holes in column Anchor /Nut shims at inside edge of <br /> base plate as a guide. See Fig.4 for hole depth,hole baseplate. Use <br /> nst <br /> spacing, and edge distance requirements. z.,\ orco siliconructionscementto <br /> adhes ive <br /> Flat hold shim in place. <br /> INSURE shims are held <br /> A CAUTION DO NOT install on as halt or other similar j Washer tightly between base <br /> p \_ / plate and floor after <br /> unstable surfaces. Columns are supported only by anchors /'. torquing anchors. <br /> in floor. Shims <br /> 1/2"Max. ►c� <br /> (13mm) Fig.5 <br /> IMPORTANT Using the horse shoe shims provided, <br /> shim each column base until each column is plumb. If NOTE: If more than 2 horse shoe shims are used at any of <br /> one column has to be elevated to match the plane of the column anchor bolts,pack non-shrink grout under the <br /> the other column,full size base shim plates should be unsupported area of the column base. Insure shims are held <br /> used (Reference FA5112 Shim Kit or FA5208 for seismic tightly between the baseplate and floor after torquing anchors. <br /> lift shims). Recheck columns for plumb. Tighten anchor <br /> bolts to an installation torque of 110 ft-lbs(149 Nm). Shim <br /> thickness MUST NOT exceed 1/2" (13mm)when using the <br /> 5-1/2" (140mm)long anchors provided with the standard <br /> lifts,Fig.5. Adjust the column extensions plumb. <br /> If anchors do not tighten to 110 ft-lbs(149 Nm) installation <br /> torque,replace concrete under each column base. See <br /> Figs.5a and 5b. <br /> • <br /> \ ° (i2 <br />