|
RXK Series Scissor Lift Racks
<br /> i„e:A__w_____ __,
<br /> wa.„,„,,,,--=--_- _- _----,,.......,
<br /> ,„._. ,,,..4,;,,,,,,..61. __ __
<br /> A41111-7"..1 .47:"-------------- 11166t-- ,,.''4 ---- ‘er,
<br /> /:,, im-rair.-- -,---- ,,,—--------—- -'Al-.ROPPPAIIImmmppp."--77---------------------4.pp--411°
<br /> "V
<br /> _ Y-ii.--- ----i-- Nkssz---------- -,:)si._
<br /> _•••••
<br /> ---,........ ,,,,,,...
<br /> .......„....40
<br /> Gently lower rack upon the leveling assemblies and adjust their side-to-side placement to align screw heads with the rigid
<br /> channel-construction of runways.
<br /> 0
<br /> n zs \ ______
<br /> ___.....
<br /> v,.r .ate. ,.;._,��.-.... :.� -.,:,..x.,.,. ...
<br /> -.I -.....,,,,
<br /> wow
<br /> Desired runway and
<br /> leveling screw contact 1
<br /> MI
<br /> % IN
<br /> Anchor each leveling assembly to bay floor using supplied anchor bolts as follows. Using leveling plates as templates,drill
<br /> two 1/2 inch (13 mm)diameter holes into floor. Use low pressure air to clean hole. Drive 1/2 inch anchors into floor until
<br /> nut contacts baseplate.Snug the anchor bolt nuts against baseplate. Using a transit theodolite,determine height of leveling
<br /> screws required to achieve the desired lowered runway height and level condition. Measure elevations while lowered on
<br /> leveling screws and then raise rack slightly to allow the bolts to be turned by hand. Repeat until desired lowered condition
<br /> is achieved. After final height adjustments are completed, use hex nuts to lock leveling screws in place.Apply a yellow and
<br /> black decal to the outer corners of leveling assemblies.
<br /> 13.4. Final Leveling
<br /> Select a vehicle that weights 3600 to 4200 pounds (1633 to 1905 Kg) and has a wheelbase of approximately 110 to 120
<br /> inches (2794 to 3048 mm). Most Mercedes sedans will meet these requirements.
<br /> Q CAUTION
<br /> Confirm that the nuts on each anchor bolt are snug against base.Since the base is not yet grouted, be cautious
<br /> when driving the vehicle onto the rack for the final leveling.
<br /> Page 42 of-89
<br /> P'kV17
<br />
|