10633 EVERGREEN WAY 2025-01-10 - Laserfiche WebLink

RXK Series Scissor Lift Racks Drive the selected vehicle onto the rack and then raise the lift to the normal alignment height. Set the runways onto the locks approximately 30 inches (762 mm) off the ground.Verify that both runways are resting firmly on the same lock positions. Make final adjustments to level the rack raised 30 inches as follows: Using a transit (most laser type levels do not have the resolution required), adjust the leveling bolts to make the turnplate and slip-plate areas are all the same height, within 1 mm (.04 inch). If the base needs elevated, slightly loosen anchors as needed to allow leveling bolts to raise base from floor. Using a bubble level, check each runway for side-to-side level. When level within 1 mm (.04 inch),tighten the anchoring bolts. Raise the runways using procedures noted earlier and set the runways on the locks near the lifts full stroke and repeat leveling procedure. Lower the rack to the ground. Leave the vehicle on the rack. Using a transit,adjust the bolts located on the leveling kit at the extreme edge of each leg so all points are the same height within 1 mm (.04 inch). Record the measurement for the rack on the ground on the chart below. (The numbers on this chart will be used later.) Snug all of the anchor nuts against the base frames and tighten all of the jam nuts. Once the lowered rack is level within 1 mm (.04 inch),remove the vehicle from rack. Table 3. LEVELNESS CHECK CHART Lift rack lowered (on any lock position) FL mm FR mm Difference mm RL mm RR mm Difference mm FL mm RR mm Difference mm FR mm RL mm Difference mm Lift rack raised(on any lock position) FL mm FR mm Difference mm RL mm RR mm Difference mm FL mm RR mm Difference mm FR mm RL mm Difference mm Acceptable height difference of wheel contact area <1 mm 13.5. Grout under Base Frames Use low pressure air to clean the gap between the base frames and the floor. Mix the grout per the instructions on the package. Grout under each base frame by filling the gap between the frame and the floor in the locations shown below. Grout under the front pivots, rear angles, and under the slider tracks from the rear angle to the leveling bolts. si NOTE To prevent liquids from collecting in the base frame area, create a small drainage channel in grout along the rear angle of base frames. (1 NOTE L� 45 degree chamfer may interfere with threshold placement and base frame channels. Ensure there is full contact between grout and the bottom surface of the frames. Considering the base frame hose channels and threshold placement,finish grout at the edges with a 45 degree chamfer where possible. Page 4 ofR.0