Laserfiche WebLink
14 Installation <br /> Approved Vent — Top Vent Configuration <br /> • Use 6-5/8" (168mm)diameter Simpson Dura-Vent Direct-Vent Pro (or GS)*. <br /> * Other vent may be approved with this stove. Check with the vent manufacturer for details. <br /> • Always use the high-wind cap (part#46DVA-VCH or 46DVA-HC). <br /> Approved Vent — Rear Vent Configuration <br /> • WITH NO VENT RISE: Must use Travis Industries Minimum Vent Kit D (Part#96200317) only. <br /> • WITH VENT RISE: Use Travis Industries Rear Vent Conversion ( Part#94400998)with 8" (204mm) <br /> diameter Simpson Dura-Vent Direct-Vent Pro (or GS)*. Always use the high-wind cap (part# <br /> 58DVA-VCH or 58DVA-HC). <br /> * Other vent may be approved with this stove. Check with the vent manufacturer for details. <br /> Vent Installation <br /> • Slide the vent sections together and turn 1/4 turn until the sections lock in place. <br /> • Screws are not required to secure the vent. However, three screws may be used to <br /> secure vent sections together if desired. 'V'(_V� <br /> • Horizontal sections require a 1/4" rise every 12" of travel <br /> • Horizontal sections require non-combustible support every three feet (e.g.: plumbing e <br /> tape). <br /> • Vent termination must not be located where it can become plugged by snow or other <br /> material. <br /> • Use the vinyl siding standoff when installing on a structure with vinyl siding. <br /> Venting termination shall not be recessed into a wall or siding. <br /> ©Travis Industries 4/19/23- 1443 Greenfield GSR2 <br />