Laserfiche WebLink
3/26/25, 9:24 AM PERM IT_B2012-040_City of Everett Permit Services 2522 Ba.htm <br />From: Drew Martin <br />Sent: Thursday, January 7, 2021 3:30 PM <br />To: ladablackmer@msn.com <br />Subject: City of Everett Permit Services: 2522 Baker Avenue (132012-040) - Building <br />Intake First Review <br />Attachments: City of Everett - Small Home Project Guidelines.pdf; General Code <br />Requirements.docx <br />Mr. Larry Blackmer, <br />Your application has been received and a permit set up. However, the submitted documents <br />are not sufficient for us to perform a review at this time. The Planning Department has also <br />determined that the project is not sufficient to perform a review; they will issue a comment <br />letter separately. Revised construction -level documents need to be submitted for review. <br />Information is attached to provide guidance. Preliminary comments are provided below to <br />assist in revising preparing the drawings, but these are not intended to provide a <br />comprehensive review. Depending on your experience with the model codes and preparing <br />documents, we recommend consulting with a design professional to assist you. <br />1. The building codes used for the design should be specified. <br />2. The plans have not been reproduced to the specified scale (i.e., %"=1'-0"). The <br />submitted drawings should be reproduced at 1:1 size. <br />3. The plans should show the demolition of the existing garage. <br />4. The plans are incomplete. Missing information includes but is not limited to: <br />a. Roof framing plans. <br />b. Wall framing plans at the garage door side. Note that this framing will support a <br />floor or storage area above; at a minimum the dead load is supported. <br />c. Material requirements. <br />d. Fastener requirements. Note that references to fastener tables in the building <br />code(s) is not acceptable. <br />5. The height of the walls appears to be up to approximately 16 feet. This exceeds the <br />unsupported wall stud height per the IRC and requires a structural design per the IBC. <br />Alternatively, the building should be provided with an intermediate floor level to <br />provide out -of -plane support of the wall framing. <br />6. The building height should be specified. The height should measure from the lowest <br />point of the floor. <br />7. The locations of doors and windows (lengths, heights, etc.) should be specified. <br />8. Additional detailing is required for the foundations. Dimension and reinforcement <br />requirements should be specified. The minimum concrete strength should be <br />specified. The minimum length of the anchors should be specified. <br />9. The wood -framed walls appear to be founded at grade (i.e., a vertical separation is not <br />provided). The walls, sill plates, sheathing, and siding are required to be deterioration - <br />resistance materials. <br />10. The "Wall Section" indicates a manufactured truss ceiling or floor at 9' above the <br />garage slab. The required construction is incomplete, including but not limited to: <br />file:///S:/KSiep/LASERFICHE- FROM TO BE SORTED FILE/Incoming/PERMIT_B2012-040_City of Everett Permit Services 2522 Ba.htm 1/2 <br />