6708 CADY RD 2025-03-31 - Laserfiche WebLink

BMP C101 : Preserving Natural Vegetation Purpose The purpose of preserving natural vegetation is to reduce erosion wherever practicable. Limiting site disturbance is the single most effective method for reducing erosion. For example,conifers can hold up to about 50 percent of all rain that falls during a storm. Up to 20-30 percent of this rain may never reach the ground but is taken up by the tree or evaporates.Another benefit is that the rain held in the tree can be released slowly to the ground after the storm. Conditions of Use Natural vegetation should be preserved on steep slopes, near perennial and intermittent water- courses or swales,and on building sites in wooded areas. . As required by local governments. • Phase construction to preserve natural vegetation on the project site for as long as possible during the construction period. Design and Installation Specifications Natural vegetation can be preserved in natural clumps or as individual trees, shrubs and vines. The preservation of individual plants is more difficult because heavy equipment is generally used to remove unwanted vegetation.The points to remember when attempting to save individual plants are: . Is the plant worth saving?Consider the location, species, size, age,vigor, and the work involved. Local governments may also have ordinances to save natural vegetation and trees. • Fence or clearly mark areas around trees that are to be saved. It is preferable to keep ground disturbance away from the trees at least as far out as the dripline. Plants need protection from three kinds of injuries: • Construction Equipment-This injury can be above or below the ground level. Damage results from scarring, cutting of roots, and compaction of the soil. Placing a fenced buffer zone around plants to be saved prior to construction can prevent construction equipment injuries. • Grade Changes-Changing the natural ground level will alter grades,which affects the plant's ability to obtain the necessary air,water, and minerals. Minor fills usually do not cause prob- lems although sensitivity between species does vary and should be checked. Trees can typ- ically tolerate fill of 6 inches or less. For shrubs and other plants,the fill should be less. When there are major changes in grade, it may become necessary to supply air to the roots of plants.This can be done by placing a layer of gravel and a tile system over the roots before the fill is made.The tile system should be laid out on the original grade leading from a dry well 2019 Stormwater Management Manual for Western Washington Volume 11-Chapter 3-Page 271