Laserfiche WebLink
41 Maintenance <br /> DANGER HIGH VOLTAGE: Disconnect power before attempting maintenance or repair. <br /> Maintaining Your Heater's Appearance <br /> Fingerprints or other marks left on the optional plated surface may become etched in place if they are not <br /> wiped clean prior to turning the heater on. Clean the plated surfaces with denatured alcohol and a soft <br /> cloth (with the heater cool). Other cleaners may leave a film that may become etched into the surface. <br /> Accent Light Replacement <br /> The accent lights in your heater provide additional lighting. The bulbs will burn out over time. To replace, <br /> follow the directions below: <br /> 1. Shut off gas to the heater and let it cool for 15 minutes. <br /> 2. Remove the glass (see page 22) and media. <br /> 3. Replace the halogen bulbs with the following bulbs: <br /> NOTE: Take care to not touch the bulbs with your fingers— use foam packing or a paper towel to <br /> handle the bulbs: <br /> 35 Watt 120 Volt T4 Halogen Bulb (GY6.35 Base) <br /> Upper Accent Lights <br /> The upper accent light can be accessed by removing the 4 screws with a '/4" nut driver, as shown below. <br /> The upper accent light assembly drops down to expose the accent light. <br /> When replacing the assembly, carefully insert the wiring into this cavity to ensure the wiring is <br /> /A not pinched. <br /> The upper accent light may now be accessed. <br /> ©Travis Industries 4/26/2023- 1558 430 MF GSR2 <br />