Laserfiche WebLink
Maintenance <br /> Loosen the two screws nearest the bulb to disengage the bulb <br /> from the holder. Remove the bulb from the holder. Replace <br /> the bulb, making sure not to touch the bulb with your fingers <br /> (grasp the bulb with the bulb packaging or a paper towel). <br /> Tighten the screws until the bulb is secure (do not over- ®� <br /> tighten; this may damage the electrical contacts on the bulb). <br /> Do not loosen these screws <br /> Micro(1/16")Standard (they hold the wires in place). <br /> or Philips Screwdriver <br /> Under Light Bulb Replacement <br /> The Under lights in your insert provide additional lighting. The bulbs will burn out over time. Replace the <br /> halogen bulbs with the following bulbs: <br /> 35 Watt 120 Volt T4 Halogen Bulb (GY6.35 Base) <br /> To replace, follow the directions below: <br /> 1. Shut off gas to the Insert and let it cool for 15 minutes. <br /> 2. Remove the glass assembly (see page 23). <br /> 3. Remove glass media from the media tray. <br /> 0 <br /> 1/4" Nut Driver <br /> 41 <br /> 4. Use a 1/4" nut driver to remove the (8) <br /> media tray attachment screws that secure <br /> the tray to the burners (set the screws <br /> aside for reinstallation). 0 <br /> 5. Lift the media tray up and out of the <br /> firebox. <br /> ©Travis Industries 4/26/2023- 1558 430 MF GSR2 <br />