Laserfiche WebLink
Optional Equipment (for qualified installers only) 51 <br /> 6. Remove and discard the stock seal plates. Install the LP seal plates as shown below. <br /> Rear <br /> Front <br /> -------------------------------------------------------- <br /> 0 1/4"Nutdriver ; ® Replace with LP Seal Plates <br /> ! <br /> Keep screws %aeal <br /> for re-installation i i <br /> i <br /> ' u Front Seal <br /> Plate i <br /> i <br /> o i <br /> o I <br /> u ! I <br /> ® Remove and Discard <br /> NG Seal Plates ;, <br /> 7. Install the LP (propane)orifices. <br /> Apply thread sealant to the LP orifices Screw each LP orifice until orifice <br /> prior to installation. Use the chart below to protrudes 15/16" (23.8mm) <br /> identify the correct orifices. indicating full insertion (use <br /> wrench to support manifold when <br /> re-attaching orifice). <br /> /qi)O 15/16" <br /> � 23.8mm <br /> Look here for the orifice identification <br /> ORIFICE SIZE ID Natural Gas LP (Propane) <br /> Front Burner Orifice #50 DMS #60 DMS <br /> Rear Burner Orifice #48 DMS 1.2mm DMS <br /> Rear e <br /> Orifice <br /> Front <br /> ■r- <br /> ©Travis Industries 4/26/2023- 1558 430 MF GSR2 <br />