Laserfiche WebLink
• Installation • qualified only) <br /> Fireplace Requirements <br /> • Insert must be placed within a code-conforming masonry fireplace or tested and listed factory-built <br /> (metal)wood-burning fireplace. Repair any fireplace damage prior to installation. <br /> • Because the insert uses a circulation blower, clean the fireplace, smoke shelf, and chimney prior to <br /> installation. <br /> • This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance <br /> produces when determining a location. <br /> • Do not place insulation or any other material on top of the insert. This may block the upper accent <br /> light ventilation, leading to premature bulb failure. <br /> • The fireplace and fireplace chimney must be clean and in good working order and constructed of non- <br /> combustible materials. <br /> • The chimney cleanouts must fit properly <br /> • Trim panels or surrounds shall not seal ventilation openings in the fireplace <br /> Fireplace Sizing 1-Piece Panel 1-Piece Panel w/Trim <br /> 0 Minimum Height 20-1/4" (515mm) 19-3/4" (502mm) <br /> \ b ® Minimum Width 30-1/2" (775mm) 30-1/4" (768mm) <br /> 19 Q Minimum Depth 15-1/2" (394mm) 14-1/4" (357mm) <br /> a d <br /> Minimum Hearth <br /> Depth (see "Hearth <br /> Requirements" on 0" (Omm) 0" (Omm) <br /> the following page <br /> for full details) <br /> h e Extension onto <br /> 0" (Omm) 1-1/4"(32mm) <br /> Hearth <br /> f <br /> C �{ The gas and electrical line should be installed prior to installing <br /> O�\\� <br /> _f the heater. <br /> d ® For tight fits (under 24")see the section "Removing the Vent <br /> Connector". <br /> OSee "Leveling Legs"for details on leveling the heater. <br /> OI Attach the "This fireplace has been altered..." plate to the fireplace (use two screws or other suitable method). You may <br /> wish to place it in a location where it will be covered by the surround panels. <br /> Fireplace Clearances to Gas Insert <br /> Side of Insert to Inside of Fireplace 1/2" (13mm) <br /> Back of Insert to Inside of Fireplace 1/2" (13mm) <br /> Top of Insert to Inside of Fireplace 3/4" (20mm) <br /> Masonry Fireplace Hearth Requirements <br /> A panel trim kit is available for this appliance. When using the kit, the appliance will sit forward of the fireplace <br /> opening 1-1/4" 32mm . <br /> WARNING: A non-combustible hearth is not required in front of the appliance. However, if the heater is installed <br /> next to the floor, we recommend a hearth to protect the flooring surface from discoloration or other <br /> negative impacts from the heater. <br /> ©Travis Industries 4/26/2023- 1558 430 MF GSR2 <br />