1200 INDUSTRY ST 2025-03-24 - Laserfiche WebLink

B. Existing materials and equipment indicated to be removed, but not to be re-used, relocated, reinstalled, delivered to the Owner, or otherwise indicated as to remain the property of the Owner, become the property of the Contractor; remove from site. C. Specific Products to be Reused: The reuse of certain materials and equipment already existing on the project site is required. 1. See Section 01 1000 for list of items required to be salvaged for reuse and relocation. 2.02 PRODUCT REQUIREMENTS (SUBSTITUTIONS) A. No alternate roofing specifications will be permitted. For any items specified as an "acceptable substitute," Contractor shall provide submittals for approval by the roofing consultant and the owner's representative. Contractor assumes all liability and costs associated thereof for installing any item not previously approved in writing by the owner's representative. B. Where the Contractor proposes to use a substitute product or a product to be considered as an "or equal"for a named material or a basis of design item, the Contractor shall submit to the Designer complete information and working drawings for such substitute item, including all necessary redesign of the system to which it is a part. C. All such redesign and all new drawings and detailing required therefore shall be prepared by the Contractor at the Contractor's expense. Where the substitution of any item or items requires a different quantity and arrangement of structure, partitions, foundations, piping, ductwork, wiring, conduit, and equipment from that specified or indicated on the Contract Drawings, the Contractor shall include the total cost of such changes as well as the necessary Designer consultation necessary to support and detail the changes, in the submittal for consideration. It shall be expressly understood that all materials named shall be furnished in full accordance with the Contract Drawings and/or Specifications. D. Owner and Consultant/ Designer reserve the right to refuse any such request for a product to be considered an approved equal by the Contractor. E. The complete and salient characteristics of materials specified by Manufacturers product number or trade name are applicable to the requirements for substitution consideration, even if the complete and salient characteristics of the specified material are not listed herein. F. The attention of the Contractor is especially directed to the requirement that, if the Contractor proposes to substitute materials or equipment as "equals"to those specified, it shall be the Contractor's responsibility to furnish complete, specific, detailed information from the manufacturer or supplier of the material or equipment he proposes to furnish, in which the requirements of the contract specifications are shown to be met, 15 working days before onsite project mobilization. Failure to submit substitute materials or equipment as"equals" 15 days before onsite project mobilization will eliminate the substitute material from consideration as an "equal"to the specified product. The information requested shall consist of a point by point comparison of the contract specification requirements with the material or equipment proposed to be furnished. If the contract specifications mention a model number and manufacturer, a point by point comparison of the complete and salient equipment characteristics of the listed model number specified under the contract and the proposed substitutes shall be furnished by the Contractor. In the event the contract specification indicates a requirement for substitute materials request to submit a specific number of operating systems and total duration of operation for each system, the Contractor shall submit the name of the owner, length of service, current contact person and title, current phone number and size of the system. The requirement for a specific number of operating systems and duration of operation for substitute materials is applicable, even if the specified product does not meet these requirements. The burden of responsibility in furnishing this information is with the Contractor. If incomplete or irrelevant data is submitted as evidence of compliance with this section of the specifications, the data will be returned to the Contractor and the request for approval will be denied. Names of manufacturers for substitute items which are not approved by the Consultant/ Designer will not be considered and the Contractor must supply the products as specified. SEA00511 / Prologis - SEA00511 01 6000 - 2 Product Requirements, - FY24- Everett 1 - Capital Equipment and Material Storage Roofing Project