222 W MARINE VIEW DR 2025-04-08 - Laserfiche WebLink

Cjertified VERSIWELD° TPO SPLIT PIPE SEALS Fab icat Accessory Features and Benefits • Delivers substantial labor savings compared to field- fabricating details • Special, more flexible TPO Detail Membrane allows for the elimination of T-Joint Covers at crossovers • Simplifies the contractor's job when flashing a pipe with an obstruction • Provides a consistent, professional finished appearance • Easier to work with in colder temperatures Required on 25-or 30-year warranties Overview Installation Confirm the outside diameter of the pipe to be flashed Versico's VersiWeld TPO Split Pipe Seals are prefabricated as most pipe sizes refer to inside diameter.TPO Split Pipe flashings made from specially designed 60-mil reinforced Seals indicate the maximum outside diameter they will fit, TPO Detail Membrane that allows for the elimination of not the size pipe they will fit. For example, a 2" PVC pipe T-Joint Covers at crossovers. Designed to fit pipes ranging has a 2 3/8" outside diameter, therefore a 3" Split Pipe from 1" (25.4 mm)to 6" (152.4 mm)in diameter, TPO Split Seal is required to fit the 2" inside diameter of the pipe. Pipe Seals can be used to wrap round pipes with obstruc- tions that would prevent the use of a standard pre-molded Each Split Pipe Seal can fit a pipe with an outside pipe seal. diameter that is 1"smaller than the Split Pipe Seal's stated size. A 3"Split Pipe Seal can fit pipes with a 2"to 3" TPO Split Pipe Seals are available in standard white and outside diameter. are packaged 8 per carton. Each carton also contains 8 1. Wrap the TO Split Pipe Seal around the pipe until the universal clamping rings.Additional sizes and colors are vertical leg is tight against the outside of the pipe.Re- available on a special-order basis. move the Split Pipe Seal from around the pipe. Versico's TO Split Pipe Seals are part of the Certified Fabri- 2. Mark the pipe around the top of the TO Split Pipe cated Accessory(CFA)program. Certified Fabricated Ac- Seal, cessories are the only factory-fabricated TPO accessories that meet the stringent quality tolerances required to be 3. Remove the TPO Split Pipe Seal from around the pipe. included in a Versico warranted roofing system. 4. Install Water Cut-Off Mastic below the mark indicating the top of the installed TO Split Pipe Seal. 5. Wrap the TO Split Pipe Seal back around the pen- etration until the vertical leg is tight against the out- side of the pipe. VERSICO A SINGLE SOURCE FOR SINGLE-PLY ROOFING`_. ROOFING SYSTEMS Versico, PO Box 1289, Carlisle, PA 17013 Tel, 800.992.7663 Fax: 717.960.4036 Web: www.versico.com