222 W MARINE VIEW DR 2025-04-08 - Laserfiche WebLink

6. Tack-weld the back edge of the pipe seal's vertical leg, ensuring that good contact is maintained be- TYPICAL PROPERTIES AND CHARACTERISTICS tween the TPO Split Pipe Seal and the pipe.This pro- cess will hold the TPO Split Pipe Seal in place. Sizes 1",2",3",4",5"and 6"O.D.Pipe (25.4,50.8,76.2,101.6,127.0 and 152.4 mm) 7. Heat-weld the entire width of the vertical overlap. Packaging 8/box Hand-roll against the outer surface of the pipe Weight(box) 1"-4lbs(2 kg) to create the pressure necessary to achieve an 2"-5lbs(2kg) acceptable weld. 3"-5 Ibs(2 kg) 4"-6 Ibs(3 kg) 8. Heat-weld the base flange to the deck membrane 5"-6lbs(3 kg) 6"-6 Ibs(3 kg) and complete the horizontal overlap weld. Material Reinforced 60-mil TPO membrane 9. Once the flashing has completely cooled, check all Color White(Gray and Tan are available as a custom order) splices for void and cold welds. Make any needed repairs. Typical properties and characteristics are based on samples tested and are not guaranteed for all samples of this product.This data and information is intended as a guide and does 10. Install a stainless steel universal clamping ring to not reflect the specification range for any particular property of this product. provide constant compression of the sealant. 11. Apply TPO Cut-Edge Sealant to all edges of the TPO LEED®INFORMATION Split Pipe Seal that are located on the horizontal plane. Do not apply the sealant to vertical surfaces. Pre-consumer Recycled content 0% REVIEW CURRENT VERSICO SPECIFICATIONS AND DETAILS Post-consumer Recycled Content 0% FOR SPECIFIC INSTALLATION REQUIREMENTS. Manufacturing Location Eugene,OR Solar Reflectance Index White:99 Precautions 1. Remove all lead and other flashing. 2. Temperature of pipe must not exceed 160OF(71°C), 3, Install a minimum of four fastening plates around pipe penetrations on mechanically attached systems. Position fastening plates around the penetration so the plates are covered by the Split Pipe Seal flange. A minimum 1 1/2"-wide weld must be maintained around the outer edge of the flange beyond the plates. If fastening plates cannot be installed in a manner to allow a minimum 1 1/2"weld, the plates must be placed outside the Split Pipe Seal flange and covered with a heat-welded reinforced TPO overlay. 4. Store Split Pipe Seal in a cool, shaded area and cover with light-colored, breathable, waterproof tarpaulins.VersiWeld TPO Split Pipe Seals or membrane that have been exposed to the weather prior to use must be prepared with Weathered Membrane Cleaner prior to hot-air welding, 0